requirements are to be applied during the design, construction, additions to, and alteration of sites, facilities, buildings, and elements to the extent required by regulations issued by Federal...
Search Results "Federal Wilderness Area"
Commonly Searched Documents
-
11B-101.1 General
- Resources for Independent Living, Inc. - Richmond and Petersburg, VA
- Boston Center for Independent Living (BCIL) - Boston, MA
- New York Association on Independent Living (NYAIL) - Albany, NY
- National Center for Blind Youth in Science (NCBYS)
- Society for Human Resource Management (SHRM)
- Meeting the Challenge, Inc.
-
Issue 22: How is accessibility for persons with low vision assessed during the design review process?
So if you show the [regional and project] managers that there is a federal law, which has governed our facilities since the first initial standards to implement that law were used by our...
- Burton Blatt Institute at Syracuse University
-
General Comments (Preamble, Section-by-Section Analysis)
., those relating to work areas), because they are included in ADAAG....
-
General Comments (Section-By-Section Analysis and Response to Comments)
., those relating to work areas), because they are included in ADAAG....
-
Final Regulatory Flexibility Analysis
First, one of the express goals of the 2004 ADAAG is harmonization of Federal accessibility guidelines with industry standards and model codes that often form the basis of State and local...
-
1009.3.3 Handrails
Where a sloped entry is provided for wave action pools, leisure rivers, sand bottom pools, and other pools where user access is limited to one area, the handrails shall not be required to...
-
[A] ALTERATION
[ADA Title III] Alterations to an Area Containing a Primary Function. [§36.403(c)]. (See “Primary Function.”)...
-
11B-802.4.2 Identification
If there is no ticket office, the functional equivalent would be in the lobby or at the entrance to the assembly area in a conspicuous location.◼...
-
11B-405.9 Edge protection
Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of ½ inch (12.7 mm) maximum within 10 inches (254 mm) horizontally of the minimum landing area...
-
216 and 703 Signs
These types of signs include: seat and row designations in assembly areas; occupant names, building addresses; company names and logos; signs in parking facilities (except those identifying...
-
Chapter 8: Special Rooms, Spaces, and Elements
Chapter 8 covers various types of elements, rooms and spaces, including assembly areas (802), dressing, fitting, and locker rooms (803), kitchens and kitchenettes (804), medical care and...
-
V. Modifications in Policies, Practices, and Procedures
Specialists are not required to provide services outside of their legitimate areas of specialization....
-
11B-213.3.6 Bathing facilities
Where two or more accessible showers are provided within the same functional area, at least one shower shall be opposite hand from the other or others (that is, one left-hand controls versus...
-
11B-209.2.2 Bus loading zones
In bus loading zones restricted to use by designated or specified public transportation vehicles, each bus bay, bus stop, or other area designated for lift or ramp deployment shall comply...
-
1016.1 General
At viewing areas, when an entity determines that a condition in 1019 does not permit full compliance on a portion of an outdoor recreation access route with a specific provision in 1016,...
-
604.5.2 Rear Wall
valves to be located in a position that conflicts with the location of the rear grab bar, then the rear grab bar shall be permitted to be split or shifted to the open side of the toilet area...