The controls, faucets, and shower spray units shall be located above the grab bar, but no higher than 48 inches (1219 mm) above the shower floor....
Search Results "Extended Floor Surface"
-
11B-608.5.3 Alternate roll-in type shower compartments
-
R402 Protruding Objects (Section-by-Section Analysis)
R402 Protruding Objects (Section-by-Section Analysis) Objects with leading edges between 685 millimeters (2.25 feet) and 2 meters (6.7 feet) above the finish surface must not protrude...
- Panda S.85 All Aluminum Slim Profile Lift and Slide System
- Milt Wright & Associates, Inc.
-
Designing the Ultimate High-End Itinerary: Why Privacy is the New Standard in Hawaiian Travel
The air feels cooler here, moving freely through open, wide-sweeping floor plans that seamlessly connect the cool indoor tile with the warm, sun-drenched lanai outside....
-
Exterior Telephones
As proposed, this provision required access to at least one telephone on a floor or level and, where multiple banks are provided, each bank....
-
Sec.36.404(a)(1)
The facility that houses a "professional office of a health care provider'' only includes floor levels housing by at least one health care provider, or any floor level designed or intended...
-
404.2.11 Vision Lights
gates, containing one or more glazing panels that permit viewing through the panels shall have the bottom of at least one glazed panel located 43 inches (1090 mm) maximum above the finish floor...
-
§ 36.404(a)(1)
The facility that houses a "professional office of a health care provider" only includes floor levels housing by at least one health care provider, or any floor level designed or intended...
-
4.1.6(1)(k)(ii)
For example, alterations to floors above or below the ground floor must be accessible regardless of whether the altered facility has an elevator....
-
11B-307.4 Vertical clearance
The leading edge of such guardrail or barrier shall be located 27 inches (686 mm) maximum above the finish floor or ground....
-
307.4 Vertical Clearance
The leading edge of such guardrail or barrier shall be located 27 inches (685 mm) maximum above the finish floor or ground....
-
How Quickly Should A Testing Entity Respond To A Request For Testing Accommodations?
Failure by a testing entity to act in a timely manner, coupled with seeking unnecessary documentation, could result in such an extended delay that it constitutes a denial of equal opportunity...
-
604.5.2 Rear Wall
The rear wall grab bar shall be 36 inches (915 mm) long minimum and extend from the centerline of the water closet 12 inches (305 mm) minimum on one side and 24 inches (610 mm) minimum on...
-
Chapter 1: Laying the Foundation: Disability Policy & Activism, 1968-1988
Congress, caught by surprise, reacted by claiming the bill had come from nowhere, that there was little precedent for such sweeping legislation, and that the deliberative process should be extended...
-
16. Opening Building Doors
Origin-to-Destination Service, September 1, 2005, available at http://www.fta.dot.gov/12325_3891.html (explaining that, “the Department does not view transit providers' obligations as extending...
-
11B-233.3.1.2.1 Elevator buildings
Residential dwelling units on floors served by an elevator shall be adaptable....
-
Addition
An expansion, extension, or increase in the gross floor area of a building or facility....
-
ADDITION
An expansion, extension, or increase in the gross floor area of a building or facility....
-
11B-233.3.1.2.1 Elevator buildings
Residential dwelling units on floors served by an elevator shall be adaptable....
-
11B-1008.3.1.1 Size
Transfer platforms shall have level surfaces 14 inches (356 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
11B-1008.3.2.1 Size
Transfer steps shall have level surfaces 14 inches (356 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
BOAT LAUNCH RAMP
[DSA-AC] A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water....
-
1008.3.2.1 Size
Transfer steps shall have level surfaces 14 inches (355 mm) deep minimum and 24 inches (610 mm) wide minimum....