[2010 ADA Standards] EXCEPTION: Existing elevator call buttons shall not be required to comply with 407.2.1.2....
Search Results "Safety Requirement"
Filters
Commonly Searched Documents
-
11B-407.2.1.2 Size and shape
-
11B-407.2.1.5 Signals
Existing elevators shall not be required to comply with 407.2.1.5....
-
11B-405.9.2 Curb or barrier
ETA Editor's Note CBC requires either a curb or a barrier for edge protection at ramps, and does not recognize the extended floor or ground surface also permitted by 2010 ADA Standards...
-
11B-804.3 Kitchen work surface
In residential dwelling units required to comply with Section 11B-809, at least one 30 inches (762 mm) wide minimum section of counter shall provide a kitchen work surface that complies...
-
§35.150 Existing facilities (Section-by-Section Analysis)
Thus, although title II may not require removal of barriers in some cases where removal would be required under title III, the program access requirement of title II should enable individuals...
-
John Brabyn, Ph.D., Director of Rehabilitation Engineering Research, Center on Low Vision and Blindness (NIDRR), Smith-Kettlewell Eye Research Institute
Safety and Mobility Photographic examples of hazards (slides 40 – 55)....
-
Providing minimal protection. (Section-by-Section Analysis)
Other commenters identified nonviolent behavioral tasks that could be construed as minimally protective, such as interrupting self-mutilation, providing safety checks and room searches,...
-
226 and 902 Dining Surfaces and Work Surfaces
226 and 902 Dining Surfaces and Work Surfaces Section 226.1 of the 2010 Standards require that where dining surfaces are provided for the consumption of food or drink, at least five...
-
State and Local Government Facilities: Guidance on the Revisions to 28 CFR Section 35.151
The Department has added a new section, designated as Sec. 35.151(a)(2), to provide that full compliance with the requirements of this section is not required where an entity can demonstrate...
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
Exception: Geometric symbols shall not be required at inmate toilet rooms and bathing rooms in detention and correctional facilities where only one gender is housed....
-
218 and 810 Transportation Facilities
The 1991 Standards at sections 4.1.3(15), 4.7.7, 4.29.2, 4.29.5, 4.29.6, and 10.3.1(8) require detectable warnings at curb ramps, hazardous vehicular areas, reflecting pools, and transit...
-
M302.4 Lift Compatibility (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients in the seated position be usable with a patient lift and comply with either the proposed clearance in base (proposed...
-
F223.1 General
EXCEPTION: Toilet rooms that are part of critical or intensive care patient sleeping rooms shall not be required to comply with 603. Advisory F223.1 General....
-
606.2 Clear Floor Space (Exception 3)
606.2 Clear Floor Space (Exception 3) This section requires clear floor space positioned for a forward approach and knee and toe clearance to be provided at lavatories and sinks....
-
INTRODUCTION:
This document addresses five categories of frequently asked questions about new California Building Code accessibility requirements for electric vehicle charging stations: General...
-
226.1 General
Sales counters and service counters shall not be required to comply with 902. 2....
-
4.1.3(17)(a)
(a) If public pay telephones, public closed circuit telephones, or other public telephones are provided, then they shall comply with 4.31.2 through 4.31.8 to the extent required by the following...
-
Passing Spaces on Trails
A 60-inch (1,525-millimeter) clear tread width is required for two wheelchairs to pass safely and comfortably on a trail....
-
Symbols of Accessibility [4.30.7]
Symbols of Accessibility [4.30.7] ADAAG requires several types of access symbols. Color contrast between symbols and background is required but the color or size is not specified....
-
Section 35.151 New construction and alterations (Section-by-Section Analysis)
The Department has added a new section, designated as § 35.151(a)(2), to provide that full compliance with the requirements of this section is not required where an entity can demonstrate...
-
11B-607.4 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-607.4.1 or 11B-607.4.2...
-
II-3.1000 General
Most requirements of title II are based on section 504 of the Rehabilitation Act of 1973, which prohibits discrimination on the basis of handicap in federally assisted programs and activities...
-
11B-607.4 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped or U-shaped grab bar meeting the dimensional requirements of Section 11B-607.4.1 or 11B-607.4.2...
-
Technically Infeasible
With respect to an alteration of a building or a facility, something that has little likelihood of being accomplished because existing structural conditions would require removing or altering...