For fixed route services, a passenger's request for a driver to position the vehicle to avoid obstructions to the passenger's ability to enter or leave the vehicle at a designated stop location...
Search Results "Designated Aisle Seat (Assembly)"
Filters
Commonly Searched Documents
-
4. Obstructions
-
11B-308.1 General
The following table provides guidance on reach ranges for children according to age where building elements such as coat hooks, lockers, or operable parts are designed for use primarily...
-
WHEELCHAIR
[ADA Title II §35.104] Wheelchair means a manually-operated or power-driven device designed primarily for use by an individual with a mobility disability for the main purpose of indoor or...
-
11B-308.1 General
The following table provides guidance on reach ranges for children according to age where building elements such as coat hooks, lockers, or operable parts are designed for use primarily...
-
11B-809.9.2 Clear width
U-shaped kitchens, designed with parallel approach at a sink, range, cooktop or other fixtures and appliances located at the base of the U without knee and toe clearance, shall provide a...
-
5. Q: What are some common problems that people with disabilities have with law enforcement?
The driver, who has a mobility disability, reaches behind the seat to retrieve her assistive device for walking. This appears suspicious to the officer....
-
Bed Height Fact Sheet
When beds are well below or above the recommended 17-23 inch range (reaching heights up to 30 inches) it is extremely difficult or impossible to transfer from the typical wheelchair seat...
-
Appendix 4 – References
AS1428.1-2001 Design for access and mobility—Part 1: general requirements for access—new building work. Sydney, Australia: Standards Australia International....
-
11B-604.8.1.1 Size
If toilet compartments are to be used to house fixtures other than those associated with the water closet, they must be designed to exceed the minimum space requirements....
-
12206(d)(2) Dissemination of information
.-- Such grants and contracts, among other uses, may be designed to ensure wide dissemination of information about the rights and duties established by this Act and to provide information...
-
Story
That portion of a building or facility designed for human occupancy included between the upper surface of a floor and upper surface of the floor or roof next above....
-
106.5.64 Story
That portion of a building or facility designed for human occupancy included between the upper surface of a floor and upper surface of the floor or roof next above....
-
§ 35.151(a)(1)
(1) Each facility or part of a facility constructed by, on behalf of, or for the use of a public entity shall be designed and constructed in such manner that the facility or part of the...
-
§ 35.172(c)
(c) Where appropriate, the designated agency shall attempt informal resolution of any matter being investigated under this section, and, if resolution is not achieved and a violation is...
-
12206(d)(2) Dissemination of information
(2) Dissemination of information Such grants and contracts, among other uses, may be designed to ensure wide dissemination of information about the rights and duties established by this...
-
Jamb Signage
...are all elevator jambs provided with signs placed on both sides designating the floor with 2" minimum height raised letters and Braille characters centered at 60" above the finish floor...
-
11B-411.2.1.4.1.2 Identification
Identification shall be placed immediately to the left of the control button to which the designation applies....
-
QUALIFIED HISTORIC BUILDING OR FACILITY
[DSA-AC] A building or facility that is listed in or eligible for listing in the National Register of Historic Places, or designated as historic under an appropriate State or local law....
-
4.13.2 Revolving Doors and Turnstiles
An accessible gate or door shall be provided adjacent to the turnstile or revolving door and shall be so designed as to facilitate the same use pattern....
-
5e.
Are signs mounted on both sides of the elevator hoistway door opening that designate the floor with 2-inch minimum-height raised letters and Braille characters centered at 60 inches above...
-
§100.205(g)(1)
units of general local government to include, in their existing procedures for the review and approval of newly constructed covered multifamily dwellings, determinations as to whether the design...
-
Stability or Stable Surface
that remains unchanged by contaminants or applied force, so that when the contaminant or force is removed, the surface returns to its original condition (2010 ADA Standards for Accessible Design...
-
4.13.2 REVOLVING DOORS AND TURNSTILES
An accessible gate or door shall be provided adjacent to the turnstile or revolving door and shall be so designed as to facilitate the same use pattern....
-
§ 35.151(a)(1)
(1) Each facility or part of a facility constructed by, on behalf of, or for the use of a public entity shall be designed and constructed in such manner that the facility or part of the...