[See subsections ...]
Search Results "Vertical Access"
Filters
Commonly Searched Documents
-
Subpart C — Requirements for Accessibility and Usability
-
Edge Protection: ADA Standard Section 405.9
Section 405.9 covers the current ADA Standards for edge protection at ramps.
-
Appalachian Trail Conservancy's "Increasing Opportunities for Access on the Appalachian Trail: A Design Guide"
The guide's theme—universal design—transcends issues solely related to access for persons with disabilities by describing how universal design reduces resource damage and maintenance, saving...
-
H. Men's Spa and Fitness Center Locker Room
Men's Spa and Fitness Center Locker Room: (1) Defendants will install a vertical, self-operating lift in the Men's Spa whirlpool in order to permit access for persons with disabilities...
-
1017.5 Tread Obstacles
The vertical alignment of joints in concrete, asphalt, or board surfaces on trails can be tread obstacles....
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
Accessible parking requirements for Stadiums
how to calculate the number of required accessible parking spaces and van-accessible parking spaces for high school sports fields...
-
Additional Technical Criteria Considered for Handrails on Ramps
M303.3.3.5 would require handrails to be provided on each side of the ramp when the vertical rise of the ramp exceeds 6 inches....
-
36 CFR Part 1193 Telecommunications Act (Section 255) Accessibility Guidelines - Preamble
SUMMARY: The Architectural and Transportation Barriers Compliance Board (Access Board or Board) is issuing final guidelines for accessibility, usability, and compatibility of telecommunications...
-
Assisting Voters with Disabilities
Do you have an assistant? Are you planning to vote? Then this video is for you! Learn more about your rights, and the do’s and don’ts when it comes to voting with an assistant.
-
Boost Your Business - Chapter 4 - Ramps
Boost Your Business - Chapter 4 - Ramps
-
Youth Vote
The Advocacy Center of Louisiana, Disability Rights New York, Disability Rights Network of Pennsylvania, and Disability Rights Washington, which operates this Rooted in Rights...
-
Section 4.1.3, Accessible Buildings: New Construction (Section-By-Section Analysis and Response to Comments)
Under Sec.4.1.3(8), at least 50% of all public entrances must be accessible....
-
2. Standing Supports
The proposed rule provided technical criteria for vertical and horizontal standing supports....
-
1010.1.5 Floor elevation
Landings shall be level except for exterior landings, which are permitted to have a slope not to exceed 0.25 unit vertical in 12 units horizontal (2-percent slope)....
-
14.1 Q. How many resident parking spaces must be made accessible at the time of construction?
The Guidelines provide that a minimum of two percent of the parking spaces serving covered dwelling units be made accessible and located on an accessible route to wheelchair users....
-
Comparison: 2010 and 1991 ADA Standards for Accessible Design - Scoping Requirements
document on scoping requirements and its companion document on technical requirements were created as references to understand the differences between the 1991 and the 2010 ADA Standards for Accessible...
-
Global Alliance on Accessible Technologies and Environments (GAATES)
The Global Alliance on Accessible Technologies and Environments (GAATES) is the leading international organization dedicated to the promotion of accessibility of the built and virtual environments...
-
Q. Must an employer modify existing facilities to make them accessible?
Must an employer modify existing facilities to make them accessible? A....
-
Paragraph (c) Access to moving text (Section-by-Section Analysis)
Paragraph (c) Access to moving text (Section-by-Section Analysis) Comment....
-
Slope Ratio
Slope Ratio—A ratio of vertical distance to horizontal distance or rise to run....
-
M305.3.2 Height (Section-by-Section Analysis)
In the final rule the Access Board retains the original requirement. This requirement has been relocated to M305.3.2.1 in the final rule....
-
Measuring Surface Firmness and Stability
To measure firmness, the precision spring applies force to the penetrator and the caliper measures the vertical displacement of the penetrator into the surface....
-
221.9 Stadium Style Movie Theaters
at least one of the following criteria: (i) It is located within the rear 60% of the seats provided in an auditorium; or (ii) It is located within the area of an auditorium in which the vertical...
