Spouts shall be no higher than 36 in (915 mm), measured from the floor or ground surfaces to the spout outlet (see Fig. 27(a))....
Search Results "Side Transfer Surface"
-
4.15.2* Spout Height
-
4.19.6* MIRRORS
Mirrors shall be mounted with the bottom edge of the reflecting surface no higher than 40 in (1015 mm) from the floor (see Fig. 31)....
-
804.2.1 Pass Through Kitchen
In pass through kitchens where counters, appliances or cabinets are on two opposing sides, or where counters, appliances or cabinets are opposite a parallel wall, clearance between all opposing...
-
1132A.1 Primary entry doors and required exit doors
The requirements of Sections 1126A.3 shall apply to maneuvering clearances at the side of the door exposed to common or public use spaces (e.g., entry or exit doors which open from the covered...
-
Can accessible spaces be parallel instead of perpendicular?
spaces be perpendicular instead of parallel, but perpendicular parking spaces are preferred at facilities located on sites because most allow users to park facing in or out depending on the side...
-
11B-406.6 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings shall extend the full width of the turning space at the demarcation between the street and the sidewalk less 2 inches (sic) (51 mm) maximum on each side....
-
Elevator Car Controls
Specifically, the ANSI standard specifies a maximum reach height of 48 inches for forward or side reaches....
-
1. Typical Issues for Individuals Who Use Wheelchairs, Scooters, or other Mobility Devices
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
4.1.2(16)
Unless otherwise specified, accessible telephones may be either forward or side reach telephones. ** A bank consists of two or more adjacent public telephones, often installed as a unit...
-
1010.1.7 Thresholds
In occupancy Group R-2 or R-3, threshold heights for sliding and side-hinged exterior doors shall be permitted to be up to 7¾ inches (197 mm) in height if all of the following apply:...
-
Viking Tactile Blue Braille and Raised Letter Sign
The ARS-LR100 is an LED Illuminated edge-lit double sided hanging Sign. It is AC powered with 3 hour battery backup....
-
Mockett CH51 Torii Coat Hook Rack
Space the hangers evenly across or bunch them together on one side to create space for a heavy coat – however the job sees fit....
-
BOAT LAUNCH RAMP
[DSA-AC] A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water....
-
H28
Is the surface of the toilet seat in this 36-inch-wide stall 17 to 19 inches above the floor? [ADA Standards §§ 4.16.3; 4.22.4] Yes No...
-
4.19.6* Mirrors
Mirrors shall be mounted with the bottom edge of the reflecting surface no higher than 40 in (1015 mm) above the finish floor (see Fig. 31)....
-
11B-502.3.3 Marking
The area within the blue borderlines shall be marked with hatched lines a maximum of 36 inches (914 mm) on center in a color contrasting with that of the aisle surface, preferably blue or...
-
11B-502.3.3 Marking
The area within the blue borderlines shall be marked with hatched lines a maximum of 36 inches (914 mm) on center in a color contrasting with that of the aisle surface, preferably blue or...
-
11B-502.3.3 Marking
The area within the blue borderlines shall be marked with hatched lines a maximum of 36 inches (914 mm) on center in a color contrasting with that of the aisle surface, preferably blue or...
-
Magnuson Group SOTARE Waste Receptacles
Designed by QDesign, SOTARE is a modular family of curvilinear waste & recycling receptacles which includes a 34-gallon half-elliptical unit and 2 quarter-elliptical units [left side...
-
PlayLSI Braille and Clock Panel Play Component
FEATURES: One side features the clock with moveable hands and Braille numbers; the other side teaches the Braille alphabet Braille numbers and letters protrude from stainless steel...
-
Magnuson Group UMEA Waste Receptacles
All UMEA models include locking front-door access, internal rigid liners and steel side panels; optional features include a sloped or flat hood and choice of side panel cutouts....
-
603.3 Mirrors
Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1015 mm) maximum above the finish floor or ground....
-
603.3 Mirrors
Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1015 mm) maximum above the finish floor or ground....
