[See subsections ...]
Search Results "Transfer Seat (Transportation)"
-
11B-218 TRANSPORTATION FACILITIES
-
11B-810 Transportation facilities
[See subsections ...]
-
11B-810 Transportation facilities
[See subsections ...]
-
5.1.1 Transfer Surface Height Adjustability Recommendation for M301 and M302
For some, independent transfers are only possible when there is minimal or no change in vertical height between the seat of the mobility device and the transfer surface....
-
49 CFR Parts 27 and 37: Transportation for Individuals With Disabilities; Reasonable Modification of Policies and Practices - Preamble
DEPARTMENT OF TRANSPORTATION 49 CFR Parts 27 and 37 [Docket OST–2006–23985] RIN 2105–AE15 Transportation for Individuals With Disabilities; Reasonable Modification of Policies...
-
Access-Able Designs Tub Transfer Bench SH-414-2SDL
Use this seat with the fold-down legs when there is no inner ledge for the regular seat to rest on. ...
-
Lawn Seating
Section 221.5 provides a new requirement that addresses lawn seating and exterior overflow areas. Such areas are required to be connected by an accessible route....
-
SPECIFIED PUBLIC TRANSPORTATION
[DSA-AC] Transportation by bus, rail or any other conveyance (other than by aircraft) provided by a private entity to the general public, with general or special service (including charter...
-
SPECIFIED PUBLIC TRANSPORTATION
[DSA-AC] Transportation by bus, rail, or any other conveyance (other than by aircraft) provided by a private entity to the general public, with general or special service (including charter...
-
4.20.3 Seat
An in-tub seat or a seat at the head end of the tub shall be provided as shown in Fig. 33 and 34. The structural strength of seats and their attachments shall comply with 4.26.3....
-
4.20.3 SEAT
An in-tub seat or a seat at the head end of the tub shall be provided as shown in Fig. 33 and 34. The structural strength of seats and their attachments shall comply with 4.26.3....
-
610.3.2 L-Shaped Seats
The rear edge of an L-shaped seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (380 mm) minimum and 16 inches (405 mm) maximum from the seat wall....
-
Companion Seats
Section 802.3 addresses companion seats, which are required to be paired with wheelchair spaces (221.3)....
-
610.3.2 L-Shaped Seats
The rear edge of an L-shaped seat shall be 2 1/2 inches (64 mm) maximum and the front edge 15 inches (380 mm) minimum and 16 inches (405 mm) maximum from the seat wall....
-
(1) Intra-Family Transfers
(1) Intra-Family Transfers: A transfer of interest in a Brand Hotel to or for the benefit of an immediate family member;...
-
11B-610.3 Shower compartment seats
In transfer-type showers, the seat shall extend from the back wall to a point within 3 inches (76 mm) of the compartment entry....
-
Safety Always Considered
Safety Always Considered You should keep in mind that carriers are obligated to take the safety of all passengers into consideration when making decisions about accommodations for...
-
5.4.1 Transfer Support Location for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.1 Transfer Support Location for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
36 CFR Part 1191 ADA and ABA Accessibility Guidelines for Emergency Transportable Housing Units
Housing Units AGENCY: Architectural and Transportation Barriers Compliance Board....
-
Transfer Steps
Transfer Steps The maximum height of transfer steps is 8 inches, although shorter heights are recommended....
-
Rehabilitation Engineering Research Center on Accessible Public Transportation
Mission The RERC on Accessible Public Transportation will research and develop methods to empower consumers, manufacturers, and service providers in the design and evaluation of accessible...
-
5.4.2 Transfer Support Length for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.2 Transfer Support Length for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
F234.3 Minimum Number
Amusement rides shall provide at least one wheelchair space complying with 1002.4, or at least one amusement ride seat designed for transfer complying with 1002.5, or at least one transfer...
-
234.3 Minimum Number
Amusement rides shall provide at least one wheelchair space complying with 1002.4, or at least one amusement ride seat designed for transfer complying with 1002.5, or at least one transfer...
