Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
Search Results "Transfer Seat (Amusement)"
-
11B-610.4 Structural strength
-
11B-610.4 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
Team and Player Seating
A provision for team and player seating areas is included in the final rule (221.2.1.4)....
-
M302.2.2 Sunset
The low transfer position height, Item A of M302.2.1, shall cease to have effect on [Insert date 5 years after date of publication in the Federal Register]. [sic]...
-
610.3.1 Rectangular Seats
The rear edge of a rectangular seat shall be 2 1/2 inches (64 mm) maximum and the front edge 15 inches (380 mm) minimum and 16 inches (405 mm) maximum from the seat wall....
-
11B-1009.5.4 Transfer steps
Transfer step height shall be 8 inches (203 mm) maximum. The surface of the bottom tread shall extend to a water depth of 18 inches (457 mm) minimum below the stationary water level....
-
11B-1009.5.4 Transfer steps
Transfer step height shall be 8 inches (203 mm) maximum....
-
1607.9.2 Grab bars, shower seats and accessible benches
[DSA-AC & HCD 1-AC] See Chapter 11A, Section 1127A.4, and Chapter 11B, Sections 11B-609.8, 11B-610.4 and 11B-903.6, for grab bars, shower seats and dressing room bench seats, as applicable...
-
1607A.9.2 Grab bars, shower seats and accessible benches
Grab bars, shower seats and accessible benches shall be designed to resist a single concentrated load of 250 pounds (1.11 kN) applied in any direction at any point on the grab bar, shower...
-
1008.3.1 Transfer Platforms
1008.3.1 Transfer Platforms. Transfer platforms shall be provided where transfer is intended from wheelchairs or other mobility aids. Transfer platforms shall comply with 1008.3.1....
-
1008.3.1 Transfer Platforms
Transfer platforms shall be provided where transfer is intended from wheelchairs or other mobility aids. Transfer platforms shall comply with 1008.3.1....
-
11B-1008.3.1.4 Transfer supports
At least one means of support for transferring shall be provided. FIGURE 11B-1008.3.1 TRANSFER PLATFORMS...
-
1008.3.1 Transfer Platforms
Transfer platforms shall be provided where transfer is intended from wheelchairs or other mobility aids. Transfer platforms shall comply with 1008.3.1....
-
§ 35.151(e)(2)
(2) Facilities with more than 50 beds covered by this section that provide common use bathing facilities shall provide at least one roll-in shower with a seat that complies with the relevant...
-
Non-compliant bathtub seat depth
The depth of the seat exceeds the 16" maximum at a depth of 21" (2010 ADA Standards section 610.2). ...
-
5.4.3 Transfer Support Height for M301 and M302
5.4.3 Transfer Support Height for M301 and M302 Description: Transfer support height applies to the vertical distance that the gripping area of the support is above the transfer surface...
-
4.3.5 Transfer Height
that are not the same elevation as the ORAR shall be between 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the floor or ground surface adjacent to the ORAR to facilitate transfer...
-
4.3.5 Transfer Height
that are not the same elevation as the ORAR shall be between 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the floor or ground surface adjacent to the ORAR to facilitate transfer...
-
11B-1009.5 Transfer systems
Transfer systems shall comply with Section 11B-1009.5....
-
11B-1009.4 Transfer walls
Transfer walls shall comply with Section 11B-1009.4....
-
11B-1009.4 Transfer walls
Transfer walls shall comply with Section 11B-1009.4....
-
11B-1009.5 Transfer systems
Transfer systems shall comply with Section 11B-1009.5....
-
11B-1009.5 Transfer systems
Transfer systems shall comply with Section 11B-1009.5....
-
11B-1009.4 Transfer walls
Transfer walls shall comply with Section 11B-1009.4....