Where play components require transfer to entry points or seats, the entry points or seats shall be 11 inches (280 mm) minimum and 24 inches (610 mm) maximum from the clear floor or ground...
Search Results "Seating Space"
Commonly Searched Documents
-
1008.4.4 Entry Points and Seats
-
11B-802.4 Designated aisle seats
Designated aisle seats shall comply with Section 11B-802.4....
-
11B-802.4 Designated aisle seats
Designated aisle seats shall comply with Section 11B-802.4....
-
11B-802.4 Designated aisle seats
Designated aisle seats shall comply with Section 11B-802.4....
-
ยง 36.302(f)(5) Hold and release of tickets for accessible seating
(5) Hold and release of tickets for accessible seating....
-
Standards Specific to Assembly Areas
Dispersion of Wheelchair Spaces: Box Seats: Wheelchair spaces must be provided and located in not fewer than 20% of all boxes.Wheelchair spaces must be dispersed vertically, horizontally...
-
4.16.3 Height
Although the seat height did not differ from ADAAG specifications, the reasons for a higher seat did differ....
-
11B-809.10.7.4 Seat height
Water closet seats shall be 15 inches (381 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat above the finish floor....
-
T213 Seats
This is similar to the requirement that wheelchair spaces be located as near as practicable to a doorway used for boarding and alighting....
-
1607.8.2 Grab bars, shower seats and dressing room bench seats
Grab bars, shower seats and dressing room bench seat systems shall be designed to resist a single concentrated load of 250 pounds (1.11 kN) applied in any direction at any point on the grab...
-
1607.8.2 Grab bars, shower seats and dressing room bench seats
Grab bars, shower seats and dressing room bench seat systems shall be designed to resist a single concentrated load of 250 pounds (1.11 kN) applied in any direction at any point on the grab...
-
1607.8.2 Grab bars, shower seats and dressing room bench seats
Grab bars, shower seats and dressing room bench seat systems shall be designed to resist a single concentrated load of 250 pounds (1.11 kN) applied in any direction at any point on the grab...
-
Sec.36.308(a)(1)(ii)(A)
(A) Are dispersed throughout the seating area;...
-
11B-221.2.4 Temporary structures
Wheelchair spaces shall not be located on, or be obstructed by, temporary platforms or other movable structures....
-
11B-221.2.4 Temporary structures
Wheelchair spaces shall not be located on, or be obstructed by, temporary platforms or other movable structures....
- Grainger Tough Guy Toilet Seat Cover Dispenser, White
-
Sec.36.308 Seating in assembly areas
Sec.36.308 Seating in assembly areas....
-
M302.1 General (Section-by-Section Analysis)
The MDE NPRM proposed that all diagnostic equipment used by patients in a seated position must comply with the technical requirements of proposed section M302....
-
Clear Floor or Ground Space: ADA Standard Section 805.3
A clear floor space complying with 305 shall be provided on each side of the bed. The clear floor space shall be positioned for parallel approach to the side of the bed....
-
4.33.3* PLACEMENT OF WHEELCHAIR LOCATIONS
Wheelchair areas shall be an integral part of any fixed seating plan and shall be dispersed throughout the seating area....
-
11B-221.2.1.6 Specialty seating areas
The number of wheelchair spaces provided in specialty seating areas shall be included in, rather than be in addition to, the total number of wheelchair spaces required by Table 11B-221.2.1.1...
-
Preferred Seat Widths
The seat width percentiles remained the same for transfers to and from the station and within each protocol....
-
M303.2.1 Orientation
Wheelchair spaces shall be designed so that a patient seated in a wheelchair orients in the same direction that a patient not seated in a wheelchair orients when the diagnostic equipment...
-
M303.2.1 Orientation
Wheelchair spaces shall be designed so that a patient seated in a wheelchair orients in the same direction that a patient not seated in a wheelchair orients when the diagnostic equipment...