Designations and indicators of car controls shall comply with Section 11B-407.4.7.
Search Results "Positioning Support"
Commonly Searched Documents
-
11B-408.4.7 Designations and indicators of car controls
- Cerebral Palsy Group
- PlayLSI: A Higher Level of Inclusive Play
-
Benches [1011.2]
Although there are no technical requirements for the bench itself, providing a bench with at least one armrest and back support that runs the full length of the bench is helpful to people...
- Moen® Chrome PosiTemp® Shower Kit
-
5.7.1 Lift Compatibility Clearance in Base for M301
5.7.1 Lift Compatibility Clearance in Base for M301 Description: For portable floor lifts to be effective, they must deploy at diagnostic equipment such that the boom of the lifts...
-
E202.7.1 Required Documentation
The responsible agency official shall document in writing: (a) the non-availability of conforming ICT, including a description of market research performed and which provisions...
-
E202.6.1 Required Documentation
The responsible agency official shall document in writing: (a) the nonavailability of conforming ICT, including a description of market research performed and which provisions cannot...
-
11B-307.4 Vertical clearance
Vertical clearance shall be 80 inches (2032 mm) high minimum. Guardrails or other barriers shall be provided where the vertical clearance is less than 80 inches (2032 mm) high. The...
-
M302.2.3 Size
Transfer surfaces shall be 21 inches (610 mm) wide minimum and 17 inches (430 mm) deep minimum. The size of transfer surfaces shall be measured from center points of their opposing...
-
M302.2 Transfer Surface
A transfer surface shall be provided and shall comply with M302.2.
-
M302.2 Transfer Surface (Section-by-Section Analysis)
This is an introductory section.
-
5.2.2 Transfer Surface Size Recommendations for M302
5.2.2 Transfer Surface Size Recommendations for M302 Description: The transfer surface is the part of the diagnostic equipment onto which patients who use mobility devices or aids...
-
M302.2.2 Size
The transfer surface shall be 21 inches (610 mm) wide minimum and 15 inches (381 mm) deep minimum. Advisory M302.2.2 Size. The size requirements in this section apply only to the...
-
M302.2 Transfer Surface
A transfer surface shall be provided and shall comply with M302.2.
-
Section 1193.33 Accessibility and usability
charge; (2) provide end-user documentation in alternate format or alternate modes upon request at no additional charge where end-user documentation is provided; (3) ensure usable customer support...
-
M302.2.4 Transfer Sides (Section-by-Section Analysis)
In the MDE NPRM, the transfer side provision for diagnostic equipment used by patients in the seated position required transfer surfaces to have the option to transfer from a mobility device...
-
Advice for Passengers with Service Animals
Although airlines are not permitted to automatically require documentation for service animals other than emotional support or psychiatric service animals, if you think it would help you...
-
M302.1 General (Section-by-Section Analysis)
The MDE NPRM proposed that all diagnostic equipment used by patients in a seated position must comply with the technical requirements of proposed section M302....
- EZ Launch for Kayaks and Canoes with Accessible Transfer Bench
-
Staff Training
Finally, training staff to properly assist with transfers and lifts, and to use positioning aids correctly will minimize the chance of injury for both patients and staff....
-
Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
herl.pitt.edu/ab/ DISCLAIMER This study was conducted by the Human Engineering Research Laboratories (HERL) from the University of Pittsburgh and VA Pittsburgh Health Care System with support...
-
Kompan, Inc. Play Structures - ELE500003 - Ridge
Requires the Premium User plan or above. (Login or upgrade your account!)
-
Kompan, Inc. Play Structures - ELE400050 - Tower
Requires the Premium User plan or above. (Login or upgrade your account!)