Ambient electromagnetic noise should not exceed 25 mA/meter or –12dB ("A" weighting) re: 100 mA/meter as measured at any seat within the looped area....
Search Results "Metering Faucet"
-
2.1.2.2 Additional Proposed Specifications (by Oval Window Audio)
-
11B-608.5 Controls
Controls, faucets, and shower spray units shall comply with Section 11B-309.4 _|Operation|_. Controls and faucets shall be of a single-lever design. [2010 ADAS] 608.5 Controls....
-
Wheelchair Work Measurement Method
Wheelchair work per meter values for straight and turning were determined for all test course surfaces except sand, under dry conditions using the Wheelchair Work Measurement Method in accordance...
-
Parallel Parking Spaces (R309.2) (Section-by-Section Analysis)
Parallel Parking Spaces (R309.2) (Section-by-Section Analysis) Where the adjacent sidewalk or available right-of-way is more than 4.3 meters (14 feet) wide, an access aisle must be provided...
-
2.2.2.2 New York State Standards
The maximum RF signal generated by the transmitter shall not exceed 8000 uV/meter at 30 meters (which accords with the FCC regulations)....
-
4.34.5.5(4) Controls
Faucets and other controls shall be located as shown in Fig. 37 and shall comply with 4.27.4....
-
4.21.5 Controls
Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 37....
-
4.21.5 CONTROLS
Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 37....
-
R208.2 Where Not Required
Detectable warning surfaces are not required at pedestrian refuge islands that are cut-through at street level and are less than 1.8 meters (6.0 ft) in length in the direction of pedestrian...
-
Perpendicular Curb Ramps (R304.2) (Section-by-Section Analysis)
The turning space must be 1.2 meters (4 feet) minimum by 1.2 meters (4 feet) minimum, and is permitted to overlap other turning spaces and clear spaces....
-
608.5.3 Alternate Roll-In Type Shower Compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
-
R402 Protruding Objects (Section-by-Section Analysis)
R402 Protruding Objects (Section-by-Section Analysis) Objects with leading edges between 685 millimeters (2.25 feet) and 2 meters (6.7 feet) above the finish surface must not protrude...
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located on the side wall of the compartment adjacent to the 16 inches (406 mm) minimum...
-
Unified Facilities Guide Specifications
02752, Portland Cement Concrete Pavement for Roads and Site Facilities, published by the National Institute of Building Sciences, it is stated that surfaces should be tested with a 4 - meter...
-
608.5.3 Alternate Roll-In Type Shower Compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
-
608.5.3 Alternate Roll-In Type Shower Compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
-
Common Requirements (R304.5) (Section-by-Section Analysis)
Common Requirements (R304.5) (Section-by-Section Analysis) The clear width of curb ramp runs (excluding flared sides), blended transitions, and turning spaces must be 1.2 meters (4 feet...
-
Attachment J: Access to Humboldt County Programs Housed in Others’ Facilities
Attachment J: Access to Humboldt County Programs Housed in Others’ Facilities
- U.S. Tape Company, Inc. Digi-Pro
-
Trail Slopes
Segments Maximum Length of Segment Between Resting Intervals Steeper than But no Steeper than 1:20 (5 percent) ) 1:12 (8.33 percent) 200 feet (61 meters...
-
Attachment I: Program Access in Existing Facilities
Attachment I: Program Access in Existing Facilities
-
608.5 Controls
Controls, faucets, and shower spray units shall comply with 309.4....
-
4.20.5 Controls
Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 34....
-
4.20.5 CONTROLS
Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 34....