A constructed feature such as a sign that overhangs an ORAR, beach access route, trail, resting interval, or passing space between 27 inches (685 mm) and 80 inches (2030 mm) above the travel...
Search Results "Floor-Level Exit Sign"
-
Protruding Object
-
What constitutes a “passenger loading zone”?
This includes those passenger drop-off or pick-up areas commonly found at airports, convention centers, schools, and many hotel entrances that have design features, signs, or markings indicating...
-
§ 38.105(b)
(b) Characters on signs required by paragraph (a) shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10, with a minimum character...
-
SIGNALIZATION OF ROUNDABOUTS
For example, a sign below the signal would read “stop on red”. A yield control would be in effect whether or not the meter was in use (i.e., the lenses were on)....
-
406.7 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
Side guard protocol
Side guard protocol: From initial setup, two side guards adjusted 6” (15.2 cm) higher than the subject’s WMD seat were attached, and subjects were asked to perform a level height transfer...
- Panda S.90 All Aluminum Slim Profile Multi-Slide Door System
- Panda TS.83 Thermally Broken Multi-Slide Door System
-
1134A.6, Item 4
Grab bar reinforcement shall be installed continuous in the walls of showers 32 inches to 38 inches (813 mm to 965 mm) above the floor....
-
Protruding Objects [4.31.4]
., 27 inches high from the floor), can be a hazard to people with vision impairments....
-
4.7.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
1134A.6, Item 4
Grab bar reinforcement shall be installed continuous in the walls of showers 32 inches to 38 inches (813 mm to 965 mm) above the floor....
-
11B-809.10.6.4 Reinforcement for grab bars
grabs bars shall comply with the following: Continuous reinforcement shall be installed in the walls of showers 30 inches (762 mm) maximum to 38 inches (965 mm) minimum above the finish floor...
-
611.4 Height
Top loading machines shall have the door to the laundry compartment located 36 inches (915 mm) maximum above the finish floor....
-
407.4.8.2.1 Signal Type
The signal shall be an automatic verbal annunciator which announces the floor at which the car is about to stop....
- Bobrick ClassicSeries LiquidMate® Surface-Mounted Soap Dispenser B-156
-
Stage or Dais
It is insulting to ask a speaker with a mobility-related disability to be the only person to present from below stage level....
-
1009.2.8 Submerged Depth
The lift shall be designed so that the seat will submerge to a water depth of 18 inches (455 mm) minimum below the stationary water level....
-
§ 35.151(i)(1)
(1) Newly constructed or altered streets, roads, and highways must contain curb ramps at any intersection having curbs or other barriers to entry from a street level pedestrian walkway....
-
§ 37.91(a)(2)
(2) To fold and store wheelchairs (to accommodate individuals who wish to transfer to coach seats) equal to not less than one half the number of single level rail passenger coaches in the...
- EZ-ACCESS Transitions® Angled Entry Mat
- Sizewise Evolution
- EZ-ACCESS Transitions® Modular Entry Mat
-
1134A.5 Bathtubs
Floor space....