The revised language clarifies the location of the entry at the end of the long side of the compartment (608.2.3)....
Search Results "Side Transfer Surface"
-
Alternate Roll-in Showers
-
T704.3.2 Automated Route Identification Announcements
Signs displaying route identification information shall be provided on the front and boarding sides of non-rail vehicles. Signs shall comply with T702....
-
407.8 Reach Height and Depth
of operable part of stationary ICT shall be at a height conforming to 407.8.2 or 407.8.3 according to its position established by the vertical reference plane specified in 407.8.1 for a side...
-
404.2.5 Thresholds
EXCEPTION: Existing or altered thresholds 3/4 inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required to comply with 404.2.5...
-
3. Protruding Objects
Is the voting area free of objects that protrude from the side more than 4 inches into the route with the bottom of the object more than 27 inches above the floor?...
-
4.10.12(3)
All floor buttons shall be no higher than 54 in (1370 mm) above the finish floor for side approach and 48 in (1220 mm) for front approach....
-
Reach Ranges and Operable Parts
REACH RANGES AND OPERABLE PARTS Forward and side reach 11B-308.2/3 Over projections 11B-308.2.2/3.2...
-
4.13.6 Maneuvering Clearances at Doors
EXCEPTION: Entry doors to acute care hospital bedrooms for in-patients shall be exempted from the requirement for space at the latch side of the door (see dimension “x” in Fig. 25) if the...
-
7.2(2)(iii)
equivalent facilitation might consist of: (1) provision of a folding shelf attached to the main counter on which an individual with disabilities can write, and (2) use of the space on the side...
-
Inventory Control Devices
A minimum 12 inch clearance is required on the push side of swinging doors when the door has both a closer and a latch....
-
Reach Ranges and Operable Parts
REACH RANGES AND OPERABLE PARTS Forward and side reach 11B-308.2/3 Over projections 11B-308.2.2/3.2...
-
4.1.4 Clear Floor or Ground Space
At least 48 inches (1220 mm) of clear floor or ground space shall surround the usable sides of a picnic table, measured from the back edge of the benches....
-
11B-604.9.5 Flush controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with Section 11B-604.8.2....
-
Accessible Counter Height
Comments from persons with disabilities considered this too high to be used as a writing surface....
-
Introduction
Wood chip surfaces on trails create difficulties for those who use mobility aids, such as wheelchairs and walkers, due to their softness, shifting, and uneven surface....
-
II. Research Methodology
Research Methodology Beginning in 2010 NCA and the Access Board began strategizing on how to provide a useful resource to trail managers on what natural surface materials were being used...
-
Limitations
One limitation associated with this study is the use of wood to construct the engineered surfaces....
-
References
References Axelson PW, Chesney D (April 1999): “Accessible Exterior Surfaces Technical Report,” USATBCB, Washington, DC....
- Bobrick B-3091 ClassicSeries® Recessed-Mounted Toilet Tissue, Seat-Cover Dispenser and Waste Disposal
- Bobrick B-3092 ClassicSeries® Recessed-Mounted Toilet Tissue, Seat-Cover Dispenser and Waste Disposal
-
Play Components
For the purpose of the guidelines, ramps, transfer systems, steps, decks, and roofs are not considered play components....
- Pilot Rock FSW-26/18 Campfire Ring
-
1.2 Background
Detectable warning surfaces are intended primarily to provide a tactile cue to pedestrians who are blind or have visual impairments....
-
11B-233.3.6 Graduate student and faculty housing at a place of education
Transfer-type showers are not permitted in lieu of a roll-in shower with a seat, and the exceptions in sections 608.3 and 608.4 for residential dwelling units are not permitted. ...