Do not design to the limits of the ADA Standards. Stay in the ranges of compliance. Think about accessibility early in a project process. The sooner the better....
Search Results "ITU-T: International Telecommunications Union Telecommunications Standardization Sector"
Filters
Commonly Searched Documents
-
Re: Steven Jones
-
Independent Living Center of the North Shore and Cape Ann Inc. (ILCNSCA) - Salem, MA
Following the federal standards and assurances, ILCNSCA is consumer controlled and community based, serves individuals of all ages who have all types of disabilities....
-
Learning Disabilities Worldwide
(LDW®), established in 1965, is the premier international professional organization dedicated to improving the educational, professional, and personal outcomes for individuals with learning...
-
CTIA-The Wireless Association®
CTIA-The Wireless Association® is an international nonprofit membership organization that has represented the wireless communications industry since 1984....
-
Section 36.406(c) Places of Lodging
, the residential standards should apply....
-
Excel Dryer, Inc. XLERATOReco® Hand Dryer
All internal parts shall be coated according to Underwriters' Laboratories, Inc. requirements. Entire mechanism shall be internally grounded....
-
Minimum Rear Wall Required.
It appears that this comment references the 2010 ADA Standards for Accessible Design for minimum bench length (42") but uses the CA - 2013 minimum bench length (48") to develop the minimum...
-
Question: Alteration vs. Maintenance for Stairs in Pre-ADA Building
If the owner chooses to only replace the handrails (complying with the current California Building Code and 2010 ADA Standards for those handrails), would that be acceptable?...
-
Employee Parking Lot
Parking lots are considered parking facilities per the 2010 ADA Standard, Section 208.2 and Advisory 208.2....
-
702.1 General
Fire alarm systems shall have permanently installed audible and visible alarms complying with NFPA 72 (1999 or 2002 edition) (incorporated by reference, see "Referenced Standards" in Chapter...
-
§1607.9 No assumption of validity.
enforcement agencies will take into account the fact that a thorough job analysis was conducted and that careful development and use of a selection procedure in accordance with professional standards...
-
1.1.8 City, county or city and county amendments, additions or deletions
Local modifications shall comply with Health and Safety Code Section 18941.5 for Building Standards Law, Health and Safety Code Section 17958 for State Housing Law or Health and Safety Code...
-
H. How Can You Tell if a Curb Ramp is Accessible?
To assist you, the next installment of this Tool Kit will include instructions on how to survey curb ramps for compliance with the ADA Standards and a Curb Ramps survey form for use in conducting...
-
[ADA Title III] Maximum Extent Feasible
feasible," as used in this section, applies to the occasional case where the nature of an existing facility makes it virtually impossible to comply fully with applicable accessibility standards...
-
Refreshment Table
Arrange all food, plates, glasses (supplement stemware with standard drinking glasses for people who have limited hand mobility), straws (for people who have difficulty drinking directly...
-
Accessible Route to Parking
Some comments pointed out that the ANSI A1171.1 standard, like the original ADAAG, specifies that "parked vehicle overhangs shall not reduce the clear width of an accessible route."...
-
611 Washing Machines and Clothes Dryers
Laundry machine manufacturers stated that this specification is inconsistent with standard industry design, which allows a 36 inch height....
-
Q3.) What are the types of “manufacturing processes” that were anticipated where the advisory says “tolerances recognized by this provision include… “those that may be a necessary consequence of a particular manufacturing process”?
To simplify the tolerance assessment, the 2010 Standards specify that the shower compartment be measured at the center points of opposing sides but the expectation is that the width at the...
-
810.2.2 Dimensions
Note to Reader: The Department of Transportation’s ADA standards indicate that compliance is required to the extent construction specifications are within a public entity's control: 810.2.2...
-
F206.4.1 Public Entrances
[ECTCR UFAS 4.1.2(8)] ETA Editor’s Note Section 1.3.7 (Accessible Public Entrances) of the Facilities Standards for the Public Buildings Service PBS—P100 (March 2014) establishes...
-
806.3 Guest Rooms with Communication Features
For headset or external amplification system compatibility, a standard subminiature jack installed in the telephone will provide the most flexibility....
-
106.5.37 Maximum Extent Feasible
Applies to the occasional case where the nature of an existing facility makes it virtually impossible to comply fully with applicable accessibility standards through a planned alteration...
-
702.1 General
Fire alarm systems shall have permanently installed audible and visible alarms complying with NFPA 72 (1999 or 2002 edition) (incorporated by reference, see "Referenced Standards" in Chapter...
