., audible tones and vibrotactile surfaces) to pedestrians who are blind or have low vision....
Search Results "End Transfer Surface"
-
R209.1 General
-
Wheelchair seating locations must provide lines of sight comparable to those provided to other spectators.
A comparable line of sight, as illustrated in the figure below, allows a person using a wheelchair to see the playing surface between the heads and over the shoulders of the persons standing...
-
1003.2.12.1 Height
Guards shall form a protective barrier not less than 42 inches (1067 mm) high, measured vertically above the leading edge of the tread, adjacent walking surface or adjacent seatboard....
-
D. Signage
be relocated to between 48 inches measured to the baseline of the lowest tactile character and 60 inches measured to the baseline of the highest tactile character above the finish floor surface...
-
A. Accessible Entrance
Accessible Entrance Having a way to get into the emergency shelter on a surface that is firm, stable, slip resistant, without steps or steep slopes, and wide enough for a person using...
-
4.4.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
Conventional Strollers
The small pivoting front wheels on these strollers make them fairly easy to maneuver, but limit their use on unpaved surfaces or rough pavement....
-
11B-602.9 Pedestrian protection
When used, wing walls or barriers shall project horizontally at least as far as the drinking fountain and to within 6 inches (152 mm) vertically from the floor or ground surface....
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
104 Conventions
104.1.1 of the 2010 Standards provides that all dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end...
-
Common Problems with Toilet Rooms
The door is centered at the end of a narrow hallway....
-
382.151 What are the requirements for providing Complaints Resolution Officials?
Foreign carriers must make a CRO available at each airport serving flights the carrier operates that begin or end at a U.S. airport....
-
18. Does an employer have to hold open an employee's job as a reasonable accommodation?
The employer must consider whether it has a vacant, equivalent position to which the employee can be reassigned for the remaining four months of leave, at the end of which time the employee...
-
Preface for Day 2: Discussion led by Earle Kennett
four issues, because, quite frankly, if you look at the agenda, we’ve got four panels, and based on what happened yesterday, I’m concluding that we’re not going to have much time at the end...
-
Requirement 6. Reinforced walls for grab bars.
Note Installation of bathtubs is not limited by the illustrative figures; a tub may have shelves or benches at either end; or a tub may be installed without surrounding walls, if there...
-
IV. Public Comments and Commenters
The proposed guidelines provided a 90-day period for the submission of comments by the public, ending September 13, 1990. The Department received 562 timely comments....
- Bradley 20.6 Gallon Waste Receptacle 355
-
Expert Report of John Rife Torkelson, theACCESSpartnership, L.P. (August 8, 2018)
Parking: The surface slope of the designated accessible van space exceeds the maximum slope allowed of 1:48 (1991 ADA Stds 4.6.3; 2010 ADA Stds 502.4)....
- Horton Profiler ® Series 2000 Linear Drive or 2000B Belt Drive System
- Skyco Drapery and Vertical Track Motorization
- Harmar IL500 Sierra Incline Platform Lift
- Speed Queen Quantum Single Load Dryer Front Control Stainless Steel Cabinet