(1) Design load. The design load of the lift shall be at least 600 pounds. Working parts, such as cables, pulleys, and shafts, which can be expected to wear, and upon which the lift...
Search Results "EV: Electric Vehicle"
Filters
Commonly Searched Documents
-
§ 38.83(b)(1) Design Load
-
§ 38.159(b)(7) Platform gaps
When the platform is at vehicle floor height with the inner barrier (if applicable) down or retracted, gaps between the forward lift platform edge and the vehicle floor shall not exceed...
-
T202.1 General
Non-rail vehicles shall provide at least one means of accessible boarding and alighting that serves each designated stop on the fixed route to which the vehicle is assigned....
-
Section 37.87 Purchase or Lease of Used Intercity and Commuter Rail Cars
Section 37.87 Purchase or Lease of Used Intercity and Commuter Rail Cars The section also parallels closely the requirements in the ADA for the purchase or lease of accessible used rail vehicles...
-
11B-202.4 Path of Travel Requirements in Alterations, Additions and Structural Repairs
• Related code amendment, adds Exception 10, which limits the costs of path of travel upgrades to 20% of the adjusted construction cost when EVCS are added to facilities where vehicle...
-
T202 Accessible Means of Boarding and Alighting
All buses, OTRBs, and vans covered under the 2016 Non-Rail Vehicle Guidelines must provide at least one means of accessible boarding and alighting that serves all designated stops on the...
-
T402 Ramps and Bridgeplates
The technical requirements for ramps and bridgeplates in the 2016 Non-Rail Vehicle Guidelines include provisions on design load, installation and operation, emergency operation, surfaces...
-
§ 38.83(c)(3) Ramp threshold
The transition from roadway or station platform and the transition from vehicle floor to the ramp or bridge plate may be vertical without edge treatment up to 1/4 inch....
-
11B-503.5 Vertical clearance
Vehicle pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone and from the passenger loading zone to a vehicular exit shall provide...
-
§ 38.159(c)(3) Ramp threshold
The transition from roadway or sidewalk and the transition from vehicle floor to the ramp may be vertical without edge treatment up to 1/4 inch (6.5 mm)....
-
810.5.3 Platform and Vehicle Floor Coordination
Advisory 810.5.3 Platform and Vehicle Floor Coordination....
-
T603 Wheelchair Securement Systems
The technical requirements in the 2016 Non-Rail Vehicle Guidelines for wheelchair securement systems include provisions on orientation, design load, movement, and rear-facing wheelchair...
-
§ 38.113(d)(4) Exception
Retrofitted vehicles shall be coordinated with the platform in existing stations such that the horizontal gap shall be no greater than 4 inches and the height of the vehicle floor, under...
-
What occupancies are or are not subject to path of travel and/or accessible routes? …buildings subject to California Building Code (CBC) Chapter 11B? …multi-family buildings subject to CBC Chapter 11A? …others?
In addition, an accessible path of travel is required where EVCS are installed at existing facilities where vehicle fueling, recharging, parking or storage is a primary function....
-
11B-205.1 General
Electrical or communication receptacles serving a dedicated use shall not be required to comply with Section 11B-309. 3. Reserved. [2010 ADA Standards] 3....
-
Is there an official review and approval process under the ADA for alternatives pursued as an “equivalent facilitation”?
There is an official review and approval process under the ADA only for transportation facilities (and vehicles) subject to DOT’s ADA regulations, which establish a process for determining...
-
T204.1 General
Doorways on non-rail vehicles shall comply with T204....
-
T203.1 General
Steps on non-rail vehicles shall comply with T405....
-
T302.1 General
Walking surfaces in non-rail vehicles shall comply with T302. EXCEPTION: Walking surfaces on lifts shall not be required to comply with T302....
-
F217.5 Shelves for Portable TTYs
a bank of telephones in the interior of a building consists of three or more public pay telephones, at least one public pay telephone at the bank shall be provided with a shelf and an electrical...
-
217.5 Shelves for Portable TTYs
a bank of telephones in the interior of a building consists of three or more public pay telephones, at least one public pay telephone at the bank shall be provided with a shelf and an electrical...
-
11B-217.5 Shelves for portable TTYs
a bank of telephones in the interior of a building consists of three or more public pay telephones, at least one public pay telephone at the bank shall be provided with a shelf and an electrical...
-
217.5 Shelves for Portable TTYs
a bank of telephones in the interior of a building consists of three or more public pay telephones, at least one public pay telephone at the bank shall be provided with a shelf and an electrical...
-
11B-217.5 Shelves for portable TTYs
a bank of telephones in the interior of a building consists of three or more public pay telephones, at least one public pay telephone at the bank shall be provided with a shelf and an electrical...