The Access Board received several comments relating to technical specifications for the design load of ramps....
Search Results "Circular Ramp"
Filters
Commonly Searched Documents
-
T402 Ramps and Bridgeplates
-
Appendix 2: Survey Forms: Curb Ramps
Describe each curb ramp’s location: Curb Ramp D: Curb Ramp A: Curb Ramp E: Curb Ramp B: Curb Ramp F: Curb Ramp C: Curb Ramp G:...
-
A4.8.2 SLOPE AND RISE
Many people who have difficulty negotiating very long ramps at relatively shallow slopes can manage very short ramps at steeper slopes....
-
E. What are the General Requirements for Curb Ramps in the ADA Standards for Accessible Design?
One way to make curb ramps compliant with Title II of the ADA is to build them in accordance with the ADA Standards. 7 Following are the key characteristics of an accessible curb ramp according...
-
4.7.6 Built-up Curb Ramps
Built-up curb ramps shall be located so that they do not project into vehicular traffic lanes (see Fig. 13)....
-
4.7.6 BUILT-UP CURB RAMPS
Built-up curb ramps shall be located so that they do not project into vehicular traffic lanes (see Fig. 13)....
-
M305.2.4.2 Non-Circular Cross Section
Transfer supports with non-circular cross sections shall have a cross-section dimension of 2 inches (51 mm) maximum and a perimeter dimension of 4 inches (100 mm) minimum and 4.8 inches...
-
1003.2.2 Boarding Piers at Boat Launch Ramps
1003.2.2 Boarding Piers at Boat Launch Ramps. Accessible routes serving boarding piers at boat launch ramps shall be permitted to use the exceptions in 1003.2.2. EXCEPTIONS: 1....
-
DSA Drawing 11B-406-4 Perpendicular Curb Ramp with No Gutter (2016 CBC)
Requires the Premium User plan or above. (Login or upgrade your account!) -
1008.2.5.2 Elevated
The rise for any ramp run connecting elevated play components shall be 12 inches (305 mm) maximum....
-
1008.2.5.2 Elevated
The rise for any ramp run connecting elevated play components shall be 12 inches (305 mm) maximum....
-
Built-Up Curb Ramps
Built-up curb ramps are permitted, but they cannot project in parking spaces, access aisles, or vehicle traffic lanes....
-
1008.2.5.2 Elevated
The rise for any ramp run connecting elevated play components shall be 12 inches (305 mm) maximum....
-
1003.2.2 Boarding Piers at Boat Launch Ramps
Accessible routes serving boarding piers at boat launch ramps shall be permitted to use the exceptions in 1003.2.2. EXCEPTIONS: 1....
-
1003.2.2 Boarding Piers at Boat Launch Ramps
Accessible routes serving boarding piers at boat launch ramps shall be permitted to use the exceptions in 1003.2.2. EXCEPTIONS: 1....
-
Why is a top landing required at curb ramps if side flares are provided?
A landing at least 36” long at the top of curb ramps provides room to approach or exit ramps and turn without encountering compound slopes of flared sides....
-
R304.5.1 Width
The width of curb ramps and blended transitions shall comply with 304.5.1.1 or 304.5.1.2, as applicable....
-
Sec.36.304(e) Portable ramps
(e) Portable ramps. Portable ramps should be used to comply with this section only when installation of a permanent ramp is not readily achievable....
-
Detectable warnings on curb ramps
Curb ramps must have detectable warnings. (DOT ADA Standard 406.8.)...
-
11B-406.5.3 Landings
[2010 ADA Standards] EXCEPTION: In alterations, where there is no landing at the top of curb ramps, curb ramp flares shall be provided and shall not be steeper than 1:12. ...
-
11B-406.5.3 Landings
A level landing, 48” deep and at least as wide as the curb ramp, is required at the top of a curb ramp. ...
-
R407.9 Edge Protection
Edge protection complying with R407.9.1 or R407.9.2 shall be provided on each side of ramp runs and ramp landings....
-
§ 38.95(c) Car ramp or bridge plate
(c) Car ramp or bridge plate—...
-
Chapter 6 Addendum: Title II Checklist (Curb Ramps and Pedestrian Crossings)
’s curb ramps....
