Grab bars shall be installed in a horizontal position, 33 inches (838 mm) minimum and 36 inches (914 mm) maximum above the finish floor measured to the top of the gripping surface, except...
Search Results "Clear Floor Area"
-
11B-609.4 Position of grab bars
-
11B-407.4.7.1.3 Symbols
The control button for the emergency stop, alarm, door open, door close, main entry floor, and phone, shall be identified with raised symbols and Braille as shown in Table 11B-407.4.7.1.3...
- Department of Homeland Security
-
11B-206.3 Location
Accessible routes shall coincide with or be located in the same area as general circulation paths....
-
11B-206.3 Location
Accessible routes shall coincide with or be located in the same area as general circulation paths....
-
11B-809.8 Doors
The floor or landing at primary entry doors, required exit doors, and secondary exit doors where a change in elevation occurs between the interior and the exterior surface of the floor or...
- LaCantina Aluminum Wood Slider System
- LaCantina Multi-slide Aluminum Wood Sliding Door System
-
Standard Roll-In Type Shower Compartments: ADA Standard Section 608.2.2
Section 608.2.2 covers the current ADA Standards for the size of standard roll-in type shower compartments.
-
11B-809.9.5 Lower shelving
Lower shelving and/or drawer space shall be provided at a height of 48 inches (1219 mm) maximum above the finish floor....
-
11B-809.10.8.3 Cabinets
The finished floor shall extend to the wall under the lavatory....
-
11B-708.4 Residential dwelling unit communication systems
Communications systems between a residential dwelling unit and a site, building, or floor entrance shall comply with Section 11B-708.4....
-
11B-809.10.8.3 Cabinets
The finished floor shall extend to the wall under the lavatory....
-
11B-809.9.5 Lower shelving
Lower shelving and/or drawer space shall be provided at a height of 48 inches (1219 mm) maximum above the finish floor....
-
11B-708.4 Residential dwelling unit communication systems
Communications systems between a residential dwelling unit and a site, building, or floor entrance shall comply with Section 11B-708.4....
- Ampetronic MLD9 MultiLoop Driver Hearing System
-
11B-705.1.2.4 Bus stops
When detectable warnings are provided at bus stop boarding and alighting areas, the detectable warnings shall extend the full width of the boarding/alighting area and shall be 36 inches...
-
11B-705.1.2.4 Bus stops
When detectable warnings are provided at bus stop boarding and alighting areas, the detectable warnings shall extend the full width of the boarding/alighting area and shall be 36 inches...
-
4.28.3(2)
(2) The color shall be clear or nominal white (i.e., unfiltered or clear filtered white light)....
-
Before January 26, 1992
Example: A small town with few public buildings operates a museum featuring the history of the area. The museum is in a two story building built in 1970, which has no elevator....
-
SAFE HARBOR
Additionally, there is no safe harbor for elements not covered in the 1991 Standards including, but not limited to, swimming pools, amusement rides, play areas, and recreational boating...
-
TEST NO. 3 – UNUSUAL CHARACTERISTICS TEST
Unusual characteristics include sites located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or code that...
-
TEST NO. 3 – UNUSUAL CHARACTERISTICS TEST
Unusual characteristics include sites located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or code that...
-
Detention and Correctional Facilities: ADA Standard Section 217.4.8
Section 217.4.8 covers scoping requirements in the current ADA Standards for TTYs in detention and correctional facilities.