Unless otherwise specified, clear floor or ground space shall be permitted to include knee and toe clearance complying with 306....
Search Results "Transfer Space"
Filters
Commonly Searched Documents
-
305.4 Knee and Toe Clearance
-
9.2.2 Minimum Requirements
An accessible unit, sleeping room or suite shall be on an accessible route complying with 4.3 and have the following accessible elements and spaces....
-
4.3.1* General
All walks, halls, corridors, aisles, skywalks, tunnels, and other spaces that are part of an accessible route shall comply with 4.3....
-
Vehicle Parking Lot
An area specifically intended for parking of more than two motor vehicles, usually divided into multiple designated parking spaces. ...
-
11B-409.3.2 Location
Elevator car doors or gates shall be positioned at the narrow end of the clear floor spaces required by Section 11B-409.4.1....
-
1133A.7, Item 2
The knee and toe space shall be 30 inches (762 mm) wide minimum, centered on the sink, countertop or appliance....
-
11B-809.9.5 Lower shelving
Lower shelving and/or drawer space shall be provided at a height of 48 inches (1219 mm) maximum above the finish floor....
-
11B-812.5.2 Accessible route to EV charger
An accessible route complying with Section 11B-402 shall be provided between the vehicle space and the EV charger which serves it....
-
11B-409.3.2 Location
Elevator car doors or gates shall be positioned at the narrow end of the clear floor spaces required by Section 11B-409.4.1....
-
11B-604.8.1.2 Doors
Doors shall not swing into the clear floor space or clearance required for any fixture....
-
Sides of Curb Ramps
Curb ramps must be connected by an accessible route which, in effect, requires space at least 36 inches in length at the top of curb ramps....
-
807 Holding Cells and Housing Cells
Revisions made to this section include: removing a provision that wheelchair turning space not extend beneath beds (807.2.1) clarifying fixture requirements in accessible...
-
Technical Memorandum TM 2014-24 Location (Accessible Routes)
Although the term "same area" is not defined in TAS, it shall mean "not in a different section of space within a building" based on TAS 106.3 and the definitions from collegiate dictionaries...
-
Pulse Duration and Flash Rate
Multiple strobes within a space, if not synchronized, can produce a composite flash rate in excess of 3 Hz....
-
Elevator Operable Parts
In addition, the Board has removed a requirement that objects mounted beneath hall call buttons protrude no more than 4 inches into the clear floor space....
-
Parallel Approach to Kitchen Sinks
Commenters recommended that a parallel approach should be allowed at kitchen sinks in spaces without a cook top or conventional range, consistent with the ANSI A117.1 standard....
-
1007.6 Areas of refuge
Every required area of refuge shall be accessible from the space it serves by an accessible means of egress....
-
Tent Pads and Tent Platforms [1013]
Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
-
1003.2.13.5 Areas of refuge
Every required area of refuge shall be accessible from the space it serves by an accessible means of egress....
-
25.1 Q. It appears from Figure 2(c) of the Guidelines (under Requirement 5) that there is a 34 inch height requirement for kitchen counters and vanities. Is this true?
Requirement 7 addresses the requirement for usable kitchens and bathrooms so that a person in a wheelchair can maneuver about the space....
-
F244.5.2 Routes to and within Common Use and Public Use Areas
connect each camping unit with mobility features with common use and public use areas serving the unit; and at least one outdoor recreation access route to connect accessible elements, spaces...
-
4.6.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
Signs [ADA Standards §216, §703]
Visual criteria address the height, style, proportion, and spacing of characters, as well as finish and contrast, line spacing, and other features (§703.5)....