Exceptions: 1. In assembly areas, handrails shall not be required on both sides of aisle ramps where a handrail is provided at either side or within the aisle width. 2. ...
Search Results "Grade 1 Braille"
-
11B-505.2 Where required
-
Tread Obstacles on Beach Access Routes
Tread obstacles on a beach access route must not be more than 1 inch (25 millimeters) high....
-
4.7.2 Controls and Operating Mechanisms
Exception 1....
-
Creation of Social Security Disability Insurance
Creation of Social Security Disability Insurance ________________________________________________________________ 8/1/1956 Congress passes the Social Security Amendments of 1956...
-
8.4 Recommendations
8.4 Recommendations 1. The system must be capable of providing 110 dB SPL and not exceed 118 dB SPL with a dynamic range on the volume control of 50 dB. 2....
-
§1630.2(j)(4)(iv)
(iv) Given the rules of construction set forth in paragraphs (j)(1)(i) through (ix) of this section, it may often be unnecessary to conduct an analysis involving most or all of these types...
-
13.3 Alteration
13.3 “Alteration” solely for purposes of this Consent Decree, shall mean and refer to an alteration to an accessible guest room or guest room toilet room that (1) increases or decreases...
-
11B-208.3.3.2
11B-208.3.3.2 Attached private garages directly serving a single residential dwelling unit shall provide at least one of the following options: 1. ...
-
11B-505.2 Where required
Exceptions: 1. In assembly areas, handrails shall not be required on both sides of aisle ramps where a handrail is provided at either side or within the aisle width. 2. ...
-
11B-407.2.2.2 Visible signals
Exceptions: 1. Reserved. 2. Reserved. [2010 ADAS] 2. Existing elevators shall not be required to comply with 407.2.2.2....
-
11B-405.3 Cross slope
Cross slope of ramp runs shall not be steeper than 1:48. [2010 ADAS] Advisory 405.3 Cross Slope. Cross slope is the slope of the surface perpendicular to the direction of travel....
-
11B-705.3 Product Approval
Only approved DSA-AC detectable warning products and directional surfaces shall be installed as provided in the California Code of Regulations (CCR), Title 24, Part 1, Chapter 5, Articles...
-
§ 37.42(a)
, intercity, or high-speed rail system must ensure, at stations that are approved for entry into final design or that begin construction or alteration of platforms on or after February 1,...
-
1132A.5.2 Strike edge maneuvering space at doors
Notes: 1. See Section 1134A for bathrooms that are required to be accessible. 2. Twenty-four inches (610 mm) is preferred for strike edge clearance....
-
11B-403.7 Continuous gradient
The slope of the resting area in all directions shall be 1:48 maximum. ETA Editor's Note CBC requirement 11B-403.7 is not present in 2010 ADAS....
-
PUBLIC BUILDING OR FACILITY
[DSA-AC] A building or facility or portion of a building or facility designed, constructed, or altered by, on behalf of, or for the use of a public entity subject to Chapter 1, Section 1.9.1.1...
-
11B-405.3 Cross slope
Cross slope of ramp runs shall not be steeper than 1:48. Advisory 11B-405.3 Cross slope. Cross slope is the slope of the surface perpendicular to the direction of travel....
-
11B-403.7 Continuous gradient
The slope of the resting area in all directions shall be 1:48 maximum. ETA Editor's Note CBC requirement 11B-403.7 is not present in the 2010 ADA Standards....
-
1009.3 Stairways
[DSA·AC & HCD 1.AC] In addition, exit stairways shall comply with Chapter 11A, Sections 1115A and 1123A, or Chapter 11B, Sections 11B-210 and 11B-504, as applicable....
-
206.6 Elevators
EXCEPTIONS: 1. In a building or facility permitted to use the exceptions to 206.2.3 or permitted by 206.7 to use a platform lift, elevators complying with 408 shall be permitted. 2....
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz...
-
106.5.57 Safe Harbor
Elements of a path of travel at a subject building or facility that have been previously constructed or altered in accordance with the April 1, 1994 Texas Accessibility Standards (TAS) are...
-
409.3.1 Power Operation
car and hoistway doors and gates shall be power operated and shall comply with ANSI/BHMA A156.19 (1997 or 2002 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)...
-
504.5 Nosings
The permitted projection of the nosing shall extend 1½ inches (38 mm) maximum over the tread below. Figure 504.5 Stair Nosings...