Detectable warnings shall be located so the edge nearest the curb is 6 inches (152 mm) minimum and 8 inches (203 mm) maximum from the line at the face of the curb marking the transition...
Search Results "Assurances from Contractors"
Filters
Commonly Searched Documents
-
11B-705.1.2.2 Curb ramps
-
1 Introduction
The following includes guidance from the revised regulations related to 28 CFR 35.151; 28 CFR part 36, subpart D; and the 2004 ADAAG....
-
After an Offer of Employment Is Made
After an employer has obtained basic medical information from all individuals who have received job offers, it may ask specific individuals for more medical information if the request is...
-
11B-806.3 Guest rooms with communication features
If a telephone-like handset is used, the external speakers can be turned off when the handset is removed from the cradle....
-
Substantive changes made to requirements for elevators
position indicators (407.4.8.2) revision of the height of tactile floor designations at hoistways (407.2.3.1) addition of an exemption for destination-oriented elevators from...
-
Free-Standing Overhead Lifts
Free-Standing Overhead Lifts Another type of overhead lift is supported from a frame that rests on the floor....
-
Is it OK to examine a patient who uses a wheelchair in the wheelchair, because the patient cannot get onto the exam table independently?
A good option is to have a table that adjusts down to the level of a wheelchair, approximately 17‒19 inches from the floor....
-
Accessible Cells in Correctional Facilities
Federal laws protect people with disabilities from discrimination by State and local governments, including entities that own or operate correctional facilities....
-
11B-404.3.1 Clear width
The minimum clear width for automatic door systems in a doorway shall provide a clear, unobstructed opening of 32 inches (813 mm) with one leaf positioned at an angle of 90 degrees from...
-
11B-809.5.2 Residential dwelling unit smoke detection system and carbon monoxide detection system
To see this Section, consult California Code of Regulations, Title 24, Part 2 - 2013 California Building Code (2013 CBC), available for purchase from International Code Council (http://www.iccsafe.org...
-
General Scoping for TTYs
This change helps clarify that TTY scoping requirements for exterior installations is to be satisfied independently from those applicable to interior locations....
-
382.65 What are the requirements concerning on-board wheelchairs?
have an accessible lavatory, the carrier must provide an on-board wheelchair on the request, with advance notice, of a person who can use the inaccessible lavatory but cannot reach it from...
-
M301.2.1 Adjustability (Section-by-Section Analysis)
least four additional transfer heights located between the low and high transfer heights, separated by one inch minimum increments; and (4) the transfer surface height will be measured from...
-
M201.2 General Exception (Section-by-Section Analysis)
In response, the Access Board has added a new provision excepting diagnostic equipment from compliance with an applicable requirement in the MDE Standards in the rare circumstance where...
-
F206.2.2 Within a Site
While the size of an area of sport activity may vary from sport to sport, each includes only the space needed to play....
-
6. Classroom Acoustics
The Board is undertaking rulemaking to address acoustics in classrooms by referencing a voluntary consensus standard developed by the Acoustical Society of America (ASA) with support from...
-
703.2.7 Character Spacing
Characters shall be separated from raised borders and decorative elements 3/8 inch (9.5 mm) minimum. [ECTCR UFAS 4.30.4]...
-
703.2.7 Character Spacing
Characters shall be separated from raised borders and decorative elements 3/8 inch (9.5 mm) minimum....
-
Team Player Seating Areas
Wheelchair spaces in the team player seating areas are exempt from the requirements related to admission price and line of sight choices in assembly areas....
-
6. Classroom Acoustics
The Board is undertaking rulemaking to address acoustics in classrooms by referencing a voluntary consensus standard developed by the Acoustical Society of America (ASA) with support from...
-
EXHIBIT B Certification of ADA Compliance
., number of fuel dispensers and parking spaces): Address of Facility: Pursuant to that certain Consent Decree, I have obtained from the Independent Licensed Architect retained...
-
221.2.3.1 Horizontal Dispersion
Horizontal dispersion of wheelchair spaces is the placement of spaces in an assembly facility seating area from side-to-side or, in the case of an arena or stadium, around the field of play...
-
703.2.7 Character Spacing
Characters shall be separated from raised borders and decorative elements 3/8 inch (9.5 mm) minimum....
-
703.3.1 Dimensions and Capitalization
corresponding dots in adjacent cells 1 0.241 (6.1 mm) to 0.300 (7.6 mm) Dot height 0.025 (0.6 mm) to 0.037 (0.9 mm) Distance between corresponding dots from...