Grab bars shall be provided on the back wall and the side wall opposite the seat. Grab bars shall not be provided above the seat....
Search Results "Grab Bar Height"
Filters
Commonly Searched Documents
-
11B-608.3.2 Standard roll-in type shower compartments
-
Chapter 2: Methodology
[See subsections ...]
-
4.26 Handrails, Grab Bars, and Tub and Shower Seats
[See subsections ...]
-
A4.26 Handrails, Grab Bars, and Tub and Shower Seats
[See subsections ...]
-
4.26 HANDRAILS, GRAB BARS, AND TUB AND SHOWER SEATS
[See subsections ...]
-
A4.26 HANDRAILS, GRAB BARS, AND TUB AND SHOWER SEATS
[See subsections ...]
-
608.3.2 Standard Roll-In Type Shower Compartments
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
-
§ 38.29(b)
(b) Handrails and stanchions shall be provided in the entrance to the vehicle in a configuration which allows persons with disabilities to grasp such assists from outside the vehicle...
-
608.3.2 Standard Roll-In Type Shower Compartments
Grab bars shall not be provided above the seat. Where a seat is not provided in standard roll-in type shower compartments, grab bars shall be provided on three walls....
-
608.3.2 Standard Roll-In Type Shower Compartments
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
-
Transfer Height: ADA Standard Section 1002.6.2
The height of transfer device seats shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
4.26.3(2)
(2) Shear stress induced in a grab bar or seat by the application of 250 lbf (1112N) shall be less than the allowable shear stress for the material of the grab bar or seat....
-
4.26.3(1)
(1) Bending stress in a grab bar or seat induced by the maximum bending moment from the application of 250 lbf (1112N) shall be less than the allowable stress for the material of the grab...
-
28.1 Q. If an architect or builder chooses to follow the bathroom specifications in Requirement 7...are the other bathrooms in the dwelling unit required to have reinforced walls for grab bars?
Requirement 6 of the Guidelines requires reinforced walls in bathrooms for later installation of grab bars....
-
Dispensers [4.16.6]
Dispensers [4.16.6] Toilet paper dispensers should be located below the side grab bar so that they do not obstruct use of this bar....
-
11B-604.7.1 Dispensers
The outlet of the dispenser shall be below the grab bar, 19 inches (483 mm) minimum above the finish floor and shall not be located behind grab bars....
-
11B-604.7.1 Dispensers
The outlet of the dispenser shall be below the grab bar, 19 inches (483 mm) minimum above the finish floor and shall not be located behind grab bars....
-
11B-604.7 Dispensers
The outlet of the dispenser shall be below the grab bar, 19 inches (483 mm) minimum above the finish floor and shall not be located behind grab bars....
-
Implication for Standards and Design
Moreover, the second phase transfer station allowed for evaluating the presence/absence of various height grab bars, a backrest added in parallel to the front edge of the transfer surface...
-
Figure 609.2.2 Grab Bar Non-Circular Cross Section – Drawing from the U.S. Access Board
-
608.3.3 Alternate Roll-In Type Shower Compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
11B-608.3.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
608.3.3 Alternate Roll-In Type Shower Compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
WET BAR
[DSA-AC] An area or space with a counter equipped with a sink and running water but without cooking facilities.
