The design and construction of new teeing grounds or the alteration of an existing teeing area must allow golf cars to enter and exit within these limits....
Search Results "Designed Use"
-
Teeing Grounds
-
604.8.1.7 Water closet
., stipulates that “…required bathing rooms and toilet rooms in new construction shall be designed and constructed…” with an accessible lavatory in the wheelchair accessible compartment...
-
11B-233.3.1.2.6.4 Test number three, unusual characteristics test
Unusual characteristics include sites located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or code that...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
Elevator Exemption (Preamble, Section-by-Section Analysis)
The term ‘‘shopping center or shopping mall’’ only includes floor levels containing at least one sales or rental establishment, or any floor level that was designed or intended for use by...
-
Elevator Exemption (Section-By-Section Analysis and Response to Comments)
The term "shopping center or shopping mall'' only includes floor levels containing at least one sales or rental establishment, or any floor level that was designed or intended for use by...
-
11B-233.3.1.2.6.1 Single building with one common (lobby) entrance
The following may only be used for determining required access to multifamily dwelling units, in a single building with one common (lobby) entrance, located on a site with difficult terrain...
-
11B-608.3 Grab bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
-
11B-608.3 Grab bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
- Inclusion Solutions Offset Door Hinge
-
Re: Steven Jones
Do not design to the limits of the ADA Standards. Stay in the ranges of compliance. Think about accessibility early in a project process. The sooner the better....
- DORMA BTS80 EMB Series Door Closer
-
SHELTERING
Generally, people with disabilities may not be segregated or told to go to “special” shelters designated for their use....
-
Subpart F -- Compliance Procedures
The Attorney General should use section 504 enforcement procedures and the Department's coordination role under Executive Order 12250 as models for regulation in this area....
-
Subpart F -- Compliance Procedures (Section-by-Section Analysis)
The Attorney General should use section 504 enforcement procedures and the Department's coordination role under Executive Order 12250 as models for regulation in this area....
- Yale Affinity® Smart Card Locks
-
11B-703.2 Raised characters
Signs that are designed to be read by touch should not have sharp or abrasive edges....
-
502.7 Relationship to Accessible Routes
Parking spaces and access aisles shall be designed so that cars and vans, when parked, cannot obstruct the required clear width of adjacent accessible routes....
-
502.7 Relationship to Accessible Routes
Parking spaces and access aisles shall be designed so that cars and vans, when parked, cannot obstruct the required clear width of adjacent accessible routes....
-
NEW CONSTRUCTION AND ALTERATIONS {35.151}
NEW CONSTRUCTION AND ALTERATIONS {35.151} New Construction Shall be designed and constructed to be readily accessible to and usable by individuals with disabilities...
-
225.2.1 Lockers
Different types of lockers may include full-size and half-size lockers, as well as those specifically designed for storage of various sports equipment....
-
9.1 GENERAL
In addition to the requirements of 4.1 to 4.33, the design of U.S. postal facilities shall comply with the requirements of 9....