Amends requirements so that operating instructions are specific to the building....
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
11B-411.2.1.2.4 Display screen
-
11B-411.2.1.2.5 Audio output
Amends requirements so that operating instructions are specific to the building....
-
702.6.1 ICC A117.1-2009
Accessible and Usable Buildings and Facilities, approved October 20, 2010, IBR approved for Appendix C, Section 402.5....
-
§ 36.601 Code
Code means a State law or local building code or similar ordinance, or part thereof, that establishes accessibility requirements....
-
206.4.8 Service Entrances
If a service entrance is the only entrance to a building or to a tenancy in a facility, that entrance shall comply with 404....
-
4.14.2 Service Entrances
A service entrance shall not be the sole accessible entrance unless it is the only entrance to a building or facility (for example, in a factory or garage)....
-
4.14.2 SERVICE ENTRANCES
A service entrance shall not be the sole accessible entrance unless it is the only entrance to a building or facility (for example, in a factory or garage)....
-
68.101(c) TAS Requirements
(c) Buildings or facilities that are leased or occupied in whole or in part for use by the state, shall meet the following requirements of TAS:...
-
SECTION 3101B SCOPE
[DSA-AC] Refer to Chapter 11B for accessibility provisions applicable to public accommodations, commercial buildings and public housing....
-
SECTION 3101B SCOPE
[DSA-AC] Refer to Chapter 11B for accessibility provisions applicable to public accommodations, commercial buildings and public housing....
-
Section 35.151(i) Curb ramps
Upon further consideration, however, the Department has concluded that the regulation should acknowledge that there are times when there are transitions from sidewalk to road surface that...
-
1009.5.7 Grab Bars
Where a grab bar is provided on each step, the tops of gripping surfaces shall be 4 inches (100 mm) minimum and 6 inches (150 mm) maximum above each step and transfer platform....
-
11B-1009.2.4 Seat
The height of the lift seat shall be designed to allow a stop at 17 inches (432 mm) minimum to 19 inches (483 mm) maximum measured from the deck to the top of the seat surface when in the...
-
Height of Tables or Counters [4.32.4]
Height of Tables or Counters [4.32.4] Counter and table surface heights (28 to 34 inches) should be specified in consideration of the intended use....
-
2.2.1 Demographic Information
., power chair, scooter), and within each type: make, model, age, armrests, footrests, drive wheels, controller, seat support surfaces and overall condition of the seating surface....
-
§ 38.95(c)(8) Handrails
grasp them from outside the car while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches and 38 inches above the ramp surface...
-
§ 38.83(c)(8) Handrails
them from outside the vehicle while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches and 38 inches above the ramp surface...
-
§ 38.125(c)(8) Handrails
grasp them from outside the car while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches and 38 inches above the ramp surface...
-
6.3 Minority Reports
6.3 Minority Reports Because the Advisory Committee did not achieve consensus on the recommendation for a minimum transfer surface height standard, U.S....
-
11B-809.12 Electrical receptacles, controls and switches
When the reach is over a kitchen work surface and base cabinet, the work surface shall be 36 inches (914 mm) maximum above the finish floor and 25 1/2 inches (650 mm) maximum in depth....
-
Definition of "Assembly Area"
The definition should also be revised, consistent with building codes, to apply to assembly areas that comprise only a portion of a facility. Response....
-
1191.1 Accessibility Guidelines
(a) The accessibility guidelines for buildings and facilities covered by the Americans with Disabilities Act are set forth in Appendices B and D to this part....
-
6.1 Q...do the dwelling units on both the first and second stories have to be made accessible?
By defining ground floor to be any floor of a building with an accessible entrance on an accessible route, the Fair Housing Act regulations recognize that certain buildings, based on the...
-
Tactile Maps for Orientation and Way Finding
The simplest form of a tactile map utilizes a raised line diagram of a layout of a building....