Chapter R4: Supplementary Technical Requirements (Section-by-Section Analysis) Chapter R4 contains supplementary technical requirements that are the same as in the 2004 ADA and ABA Accessibility...
Search Results "ADA Standard"
Filters
Commonly Searched Documents
-
Chapter R4: Supplementary Technical Requirements (Section-by-Section Analysis)
-
R218 Doors, Doorways, and Gates (Section-by-Section Analysis)
, and Gates (Section-by-Section Analysis) Doors, doorways, and gates to pedestrian facilities such as transit shelters must comply with applicable technical requirements in the 2004 ADA...
-
FORCED ACCEPTANCE {35.130}
ACCEPTANCE {35.130} “Nothing in this part shall be construed to require an individual with a disability to accept an accommodation, aid, service, opportunity, or benefit provided under the ADA...
-
2b
[ADA Stds. 4.21.7] Yes __ No __ N/A __ Comments: ___________________________________________...
-
1a
Do all small showers, if provided in accessible guestroom/suites, measure exactly 36" wide by 36" deep as shown in Figure 35(a) below: [ADA Stds. 4.21.2] Yes __ No __ N/A __ Comments:...
-
11B-605.1 General
[2010 ADAS] Advisory 605.1 General. Stall-type urinals provide greater accessibility for a broader range of persons, including people of short stature....
-
5b. Ramp Slope
[ADA Stds 4.7.2] Note: 1:12 is one inch of vertical height for 12 inches of horizontal distance. Yes _____ No _____...
-
§ 37.125(h)
(h) The entity may establish an administrative process to suspend, for a reasonable period of time, the provision of complementary paratransit service to ADA eligible individuals who establish...
-
§ 37.155(a)(2)
(2) Average number of trips made by the entity's general population, on a per capita basis, compared with the average number of trips to be made by registered ADA paratransit eligible persons...
-
Shower Compartment Seats: ADA Standard Section 610.3
Section 610.3 covers the current ADA Standards for shower compartment seats.
-
E202.6.1 Required Documentation (Section-by-Section Analysis)
Documentation (Section-by-Section Analysis) This section proposes to require that agencies document in writing the basis for determining that ICT fully conforming to applicable 508 Standards...
-
Sections 4.8.5 and 4.9.4
• Sections 4.8.5 and 4.9.4 of the 1991 Standards require handrail gripping surfaces to be continuous, and to be uninterrupted by newel posts, other construction elements, or obstructions...
-
QUALIFIED INTERPRETERS
An individual does not have to be certified in order to meet this standard....
-
101.1 General
These standards are intended to be consistent to those contained in the 2010 Standards for Accessible Design, and are generally the same except as noted in italics....
-
R105 Definitions (Section-by-Section Analysis)
Collegiate dictionaries are used to determine the meaning of terms that are not defined in the proposed guidelines, referenced MUTCD standards, or regulations issued by federal agencies...
-
Q5: Should a school district revise its policies and procedures regarding the determination of coverage and provision of services under Section 504 and Title II?
A: Yes, if those policies and procedures do not implement the Amendments Act's new legal standards....
-
A.2.ii. - Should EIT be compatible with assistive technology?
In some cases, the standards require that the acquired EIT be readily usable without the need for assistive devices....
-
A. Accessibility Laws
. §§ 12101, et seq. and all of its implementing regulations and design standards; the Rehabilitation Act of 1973, 29 U.S.C. §§ 790, et seq. and all of its implementing regulations and design...
-
Minimum Clear Headroom
The commenters stated that standard doors provide a height range from 75 to 79 inches, and that an 80-inch specification would considerably increase the cost of each door installed....
-
407.7 Color (Section-by-Section Analysis)
The proposed section is the same as existing 508 Standards § 1195.25(g), and is consistent with 255 Guidelines § 1193.41(c)....
-
E102.5 Internet Engineering Task Force (IETF)
Copies of the referenced standard may be obtained from the Internet Engineering Task Force (http://www.ietf.org/)....
-
4.10.12(2)
All control buttons shall be designated by Braille and by raised standard alphabet characters for letters, arabic [sic] characters for numerals, or standard symbols as shown in Fig. 23(a...
-
Mirrors [4.19.6]
The mounting height of the bottom of mirrors at accessible lavatories (40 inches maximum above the floor) is based on the standard eye level range of adults seated in wheelchairs (43 to...
-
205 Operable Parts
1991 Standards for Accessible Design 2010 Standards for Accessible Design What’s New/Different 4.1.3(13) Controls...