multi-fold or 100 C-fold paper towels 1.25 gallon waste capacity Model 229 - Recessed Model 229-10 - Semi-recessed (recesses 2"; projects 2") Model 229-11 - Surface...
Search Results "Ground Surface"
Filters
Commonly Searched Documents
-
Bradley Low Capacity Towel Dispenser / 1.25 Gallon Waste Receptacle 229
-
Bradley Low Capacity Towel Dispenser 2442
Holds 400 multi-fold or 300 C-fold paper towels Model 2442 - Recessed BradEX Model 2442-10 - Semi-recessed (recesses 2-1/8"; projects 2") Model 2442-11 - Surface...
-
Bradley High Capacity Towel Dispenser / 8.2 Gallon Waste 238
Single, multi or C-fold towels 8.2 gallon waste capacity Model 238 - Recessed Model 238-10 - Semi-recessed (recesses 3-1/2"; projects 4") Model 238-11 - Surface...
-
B. What Is a Curb Ramp?
The gutter is the roadway surface immediately next to the curb ramp that runs along the curb. 1 28 C.F.R. Part 36, Appendix A, § 3.4....
-
R204.2 Pedestrian Circulation Paths
The NPRM proposed to define a pedestrian circulation path as a prepared exterior or interior surface provided for pedestrian travel in the public right-of-way. See R105.5....
-
809.2 Residential Dwelling Units with Mobility Features
809.2 Residential Dwelling Units with Mobility Features As discussed below, the final rule adds technical requirements to this section for floor surfaces, bedrooms, and weather alert...
-
Spy City Café
The bottom edges of the reflecting surfaces of the mirrors in the men's and women's toilet rooms located outside the Café and designated as accessible are mounted 57 ½" [sic] from the finished...
-
M301.3.3 Head and Back Support
This is consistent with ANSI/AAMI HE 75 which recommends that the “support surface needs to be adjustable or have adjustable features (e.g., for the head, neck, back, lumbar region, leg,...
-
604.7 Dispensers
paper dispensers are installed above the side wall grab bar, the outlet of the toilet paper dispenser must be 48 inches (1220 mm) maximum above the finish floor and the top of the gripping surface...
-
B) Accessible Route
be at least 36 inches wide, have no abrupt vertical changes in level (such as a step), have a running slope no more than 1:12 in most cases, and meet other requirements for cross slope, surface...
-
Parking Spaces [4.6.3]
A maximum slope of 2% is required in all directions for both the space and access aisle since level surfaces are important for wheelchair transfer to and from vehicles....
-
Location [§208.3]
Locating accessible spaces required for a parking structure in a surface lot often will not qualify for this exception because such a location typically offers less convenience, security...
-
Slope [§405.2] and Cross Slope [§405.3]
will accommodate most irregularities or variances due to construction methods or materials according to a study sponsored by the Board (“Dimensional Tolerances in Construction and for Surface...
-
Some existing measurement protocols
Some existing measurement protocols Currently there are no generally accepted measurement protocols for determining the slope, flatness, or waviness of floor surfaces in terms of accessibility...
-
Changes in Level at Entry to Wheelchair Spaces (M303.3)
with drop offs ½ inch or greater would be required to provide edge protection 2 inches high minimum on each side to prevent users from inadvertently travelling off the sides of the ramped surface...
-
11B-704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (864 mm) minimum above the finish floor....
-
1133A.2 Clear floor space
A clear floor space at least 30 inches (762 mm) by 48 inches (1219 mm) that allows either a parallel or a forward approach shall be provided at the work surface required by Section 1133A...
-
11B-704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (864 mm) minimum above the finish floor....
-
Bradley Square Multipurpose Basin HS-TS1
ADA and ANSI complaint Clean, contemporary lines Flat bottom design maximizes basin capacity for multipurpose use Basin constructed of vandal-resistant Terreon Solid Surface Material...
-
Bradley Center-Pull Towel Dispenser/12 Gallon Waste 236
12 gallon waste capacity Model 236 - Recessed (recesses 7-1/2"; projects 4") Model 236-10 - Semi-recessed (recesses 3-5/8"; projects 7 7/8") Model 236-11 - Surface...
-
Bradley High Capacity Towel Dispenser 247
Holds 1000 single-fold, 800 multi-fold or 500 C-fold paper towels Model 247 - Recessed Model 247-10 - Semi-recessed (recesses 3-1/2"; projects 4") Model 247-11 - Surface...
-
Bradley Oval Multipurpose Basin HS-TO1
ADA and ANSI compliant Clean, contemporary lines Flat bottom design maximizes basin capacity for multipurpose use Basin constructed of vandal-resistant Terreon Solid Surface Material...
-
Bradley Low Capacity Towel Dispenser / 2 Gallon Waste Receptacle 2291
or 350 C-fold paper towels 2 gallon waste capacity Model 2291 - Recessed BradEX Model 2291-10 - Semi-recessed (recesses 2"; projects 2") Model 2291-11 - Surface...
-
Bradley Rectangular Multipurpose Basin HS-TR1
ADA and ANSI compliant Clean, contemporary lines Flat bottom design maximizes basin capacity for multipurpose use Basin constructed of vandal-resistant Terreon Solid Surface Material...
