Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
Search Results "Ground Surface"
-
1002.6 Transfer Devices for Use with Amusement Rides
-
11B-1002.6 Transfer devices for use with amusement rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
1002.6 Transfer Devices for Use with Amusement Rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
When Ramps Are Required
Rise of a ramp is the amount of vertical distance the inclined or slanted surface ascends or descends....
-
R210.3 Shared Use Paths
Objects shall not overhang or protrude into any portion of a shared use path at or below 2.4 m (8.0 ft) measured from the finish surface....
-
1002.6 Transfer Devices for Use with Amusement Rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
4. Wheelchair seat depth
The median seat depth across different wheeled mobility devices would provide a reference value for the depth of other common seating surfaces....
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
The need to reach heights above 32 inches interferes with efforts to lower the transfer surface height....
-
Initial Measures and Transfer Setup
This approach is also widely promoted in rehabilitation research (A Clinical Application Guide to Standardized Wheelchair Seating Measurements of the Body and Seating Support Surfaces, See...
-
3. FIXTURES and HARDWARE
If self-closing valves are used, the faucet shall remain open for at least 10 seconds.”xxii Sinks Exposed Pipes and Surfaces: Hot water and drain pipes under lavatories...
-
The Purpose of FSORAG and FSTAG
has to comply with the guidelines; definitions of terms; and technical requirements defining the physical characteristics of accessible features, such as width, height, slope, length, surface...
-
Standardized Tests of Physical Fitness and Community Ambulation
The subjects rated the level of difficulty from 1 to 10 for both straight travel and turning on the surface using the Level of Difficulty Rating Scale....
-
Multiple Parking Facilities on a Site
., surface lot versus parking garage or deck); dedicated to, and separately serve, different facilities on a site; segmented and separated by guard rails, fencing, or barriers...
-
11B-1002.6 Transfer devices for use with amusement rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
11B-1002.6 Transfer devices for use with amusement rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
A. ACCESSIBLE SEATING
Wheelchair Spaces shall be thirty six (36) inches wide (or as otherwise required by Section 802), located on a level floor surface, and shall adjoin accessible routes. ...
-
Fixed position maps and kiosks
While it is normally more convenient and practical to mount these maps on vertical surfaces, as is typical for publicly displayed maps, it is better to place tactile maps on a horizontal...
-
Accessibility - Flatness and Lippage
Conformance to this standard requires that subfloor surfaces conform to the following: no variation greater than 1/4" in 10 feet, nor 1/16" in 1 ft. from the required plane....
-
307.2 Protrusion Limits
Objects with leading edges more than 27 inches (685 mm) and not more than 80 inches (2030 mm) above the finish floor or ground shall protrude 4 inches (100 mm) maximum horizontally into...
-
11B-307.2 Protrusion limits
Objects with leading edges more than 27 inches (686 mm) and not more than 80 inches (2032 mm) above the finish floor or ground shall protrude 4 inches (102 mm) maximum horizontally into...
-
307.2 Protrusion Limits
Objects with leading edges more than 27 inches (685 mm) and not more than 80 inches (2030 mm) above the finish floor or ground shall protrude 4 inches (100 mm) maximum horizontally into...
-
§ 382.5 Qualified individual with a disability
Qualified individual with a disability means a individual with a disability who -- (a) With respect to accompanying or meeting a traveler, use of ground transportation, using terminal...
-
§382.43(c)
., a combination of air transportation and ground or cruise accommodations), or tour component (e.g., a hotel stay) that must be purchased with air transportation, you must ensure the public-facing...
-
§382.3 Qualified individual with a disability
and (ii) Meets reasonable, nondiscriminatory contract of carriage requirements applicable to all passengers; or (b) Who, with respect to accompanying or meeting a traveler, using ground...