Where provided, key surfaces not on active areas of display screens, must be raised above surrounding surfaces....
Search Results "Extended Floor Surface"
-
§ 382.57(c)(6)(i) Input controls
-
§ 27.71(k)(6)(i) Input controls
Where provided, key surfaces not on active areas of display screens, must be raised above surrounding surfaces....
-
M301.3 Transfer Supports
Section may be discontinuous (see Rationale) along the length of the Gripping Surface not exceeding 20% of the length of the gripping surface....
-
505.5 Clearance
Clearance between handrail gripping surfaces and adjacent surfaces shall be 1½ inches (38 mm) minimum. Figure 505.5 Handrail Clearance...
-
4.8.5(5)
(5) Top of handrail gripping surfaces shall be mounted between 34 in and 38 in (865 mm and 965 mm) above ramp surfaces....
- AJW Architectural Products U127 40 oz. Vertical Liquid Soap Dispenser w/ Push-up Valve - Surface Mounted
- AJW Architectural Products U840 Dual Hooded Toilet Tissue Dispenser w/Auto Reserve - Surface Mounted - Non-Controlled
-
Running Slope of Ramps Deployed to Roadways or Curb-Height Bus Stops
Because of their lower floor and flat entry area, low floor buses can use ramps (instead of lifts) to provide access for passengers with disabilities....
-
11B-203.11 Water slides
An accessible route complying with Division 4 shall be provided to the ground- or floor-level entry points, where provided, of stairs, ladders, or other means of reaching the raised elements...
-
11B-203.11 Water slides
An accessible route complying with Division 4 shall be provided to the ground- or floor-level entry points, where provided, of stairs, ladders, or other means of reaching the raised elements...
-
Clearance Reduction: ADA Standard Section 306.3.4
Section 306.3.4 covers the current ADA Standards for knee clearance width reduction.
- Inclusion Solutions BallotCall™ Alert System
-
11B-1008.2.5.3.2 Handrail height
The top of handrail gripping surfaces shall be 20 inches (508 mm) minimum and 28 inches (711 mm) maximum above the ramp surface....
-
1008.2.5.3.2 Handrail Height
The top of handrail gripping surfaces shall be 20 inches (510 mm) minimum and 28 inches (710 mm) maximum above the ramp surface....
-
11B-1008.2.5.3.2 Handrail height
The top of handrail gripping surfaces shall be 20 inches (508 mm) minimum and 28 inches (711 mm) maximum above the ramp surface....
-
11B-1008.2.5.3.2 Handrail height
The top of handrail gripping surfaces shall be 20 inches (508 mm) minimum and 28 inches (711 mm) maximum above the ramp surface....
-
1008.2.5.3.2 Handrail Height
The top of handrail gripping surfaces shall be 20 inches (510 mm) minimum and 28 inches (710 mm) maximum above the ramp surface....
-
11B-1003.2.1 Boat slips
Where handrail extensions are provided on gangways or transition plates, the handrail extensions shall not be required to be parallel with the ground or floor surface. 7. ...
-
APPENDIX A
The presentation revisited some of the recommendations made at the January meeting by the practitioners and clinicians about acceptable transfer surface heights....
-
11B-1003.2.1 Boat slips
The vertical distance is 10 feet (3050 mm) between the elevation where the gangway departs the landside connection and the elevation of the pier surface at the lowest water level....
- American Dryer, Inc Wall Guard Accessory
-
Purpose
and other recreational properties with trails in the United States with descriptive and/or comparative information about the status of construction practices of pedestrian/hiker, natural surface...
-
Unified Facilities Guide Specifications
Facilities Guide Specifications In Section 02752, Portland Cement Concrete Pavement for Roads and Site Facilities, published by the National Institute of Building Sciences, it is stated that surfaces...
-
Error/Omission: The built-up curb ramp projects into the access aisle.
Result: When an access aisle has a sloped surface, a wheelchair may roll away from a car or van preventing the wheelchair user from getting out of the vehicle....