Retrofitted vehicles shall be coordinated with the platform in new and key stations such that the horizontal gap shall be no greater than 4 inches and the height of the vehicle floor, under...
Search Results "Platform Edge"
Commonly Searched Documents
- 
    
  
  § 38.93(d)(4) Exception
  
 - 
    
  
  10.3.2(4)
  
(4) In light rail, rapid rail and commuter rail key stations, the platform or a portion thereof and the vehicle floor shall be coordinated so that the vertical difference, measured when...
 - 
    
  
  206.7 Platform Lifts, F206.7 Platform Lifts
  
206.7 Platform Lifts F206.7 Platform Lifts These sections specify where platform lifts are permitted as a component of an accessible route in new construction....
 - 
    
  
  502.2.1 User Control of Accessibility Features
  
Platforms shall provide user control over platform features that are defined in the platform documentation as accessibility features....
 - 
    
  
  502.2.1 User Control of Accessibility Features
  
Platform software shall provide user control over platform features that are defined in the platform documentation as accessibility features....
 - 
    
  
  Elevators and Platform Lifts
  
Elevators and Platform Lifts In addition to regular elevators, limited use/limited application elevators or platform lifts that comply with ADAAG may be used instead of gangways as part...
 - 
    
  
  1013.1 General
  
Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
 - Figure 1008.3.1 Transfer Platforms – Drawing from the U.S. Access Board
 - 
    
  
  405.9.1 Extended Floor or Ground Surface
  
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505. Advisory 405.9.1 Extended...
 - 
    
  
  405.9.1 Extended Floor or Ground Surface
  
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505.
 - 
    
  
  § 38.125(c)(4) Ramp barriers
  
(4) Ramp barriers. Each side of the ramp or bridge plate shall have barriers at least 2 inches high to prevent mobility aid wheels from slipping off.
 - 
    
  
  9. Platform lift
  
Platform lift 4.11 May be used in lieu of an elevator or ramp under certain conditions....
 - 
    
  
  810.5.1 Slope
  
Rail platforms shall not exceed a slope of 1:48 in all directions....
 - 
    
  
  11B-810.5.1 Slope
  
Rail platforms shall not exceed a slope of 1:48 in all directions....
 - 
    
  
  810.5.1 Slope
  
Rail platforms shall not exceed a slope of 1:48 in all directions....
 - 
    
  
  11B-810.5.1 Slope
  
Rail platforms shall not exceed a slope of 1:48 in all directions....
 - 
    
  
  11B-810.5.1 Slope
  
Rail platforms shall not exceed a slope of 1:48 in all directions....
 - 
    
  
  810.5.1 Slope
  
Rail platforms shall not exceed a slope of 1:48 in all directions....
 - 
    
  
  Changes in Level and Horizontal Gaps
  
The referenced vehicle guidelines (like those of the proposed rule) permit the use of mini high platforms, car-borne or platform-mounted lifts, ramps or bridge plates, or manually deployed...
 - Figure 1003.3.2 (Exception 2) Edge Protection at Boarding Piers – Drawing from the U.S. Access Board
 - Figure 1003.3.1 (Exception 2) Edge Protection at Boat Slips – Drawing from the U.S. Access Board
 - SuperDeck Fishing Dock & Deck
 - 
    
  
  4.3.4 Tent Pad or Platform Surface
  
Tent pads and platforms shall have a surface that is firm and stable and is designed to allow use of tent stakes and other tent securing devices. Exception. ...
 - 
    
  
  1013.4 Height
  
This section requires tent platforms to be 19 inches high maximum measured from the clear ground space to the tent platform surface....