The NPRM had proposed a three-second time limit....
Search Results "NPRM: Notice of Proposed Rulemaking"
Filters
Commonly Searched Documents
-
Paragraph (g) Operable without time-dependent controls (Section-by-Section Analysis)
-
M301.3.1 Transfer Supports (Section-by-Section Analysis)
The MDE NPRM proposed to require transfer supports to be provided for use with transfer sides on diagnostic equipment used by patients in the supine, prone, or side-lying position, and that...
-
M302.3.3 Head and Back Support (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed to place the requirements for head and back support for diagnostic equipment used by patients in the seated position in M302....
-
M301.3.3 Head and Back Support (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed to place the requirements for head and back support for diagnostic equipment used by patients in the supine, prone, or side-lying position in M301...
-
I. Adoption of Final Guidelines
The Department of Housing and Urban Development (Department) is adopting as its Fair Housing Accessibility Guidelines, the design and construction guidelines set forth in this notice (Guidelines...
-
M301.4.2 Clearance Around Base (Section-by-Section Analysis)
The MDE NPRM proposed certain requirements to provide clearance around the base of the diagnostic equipment to allow the legs of the portable floor lift to straddle the base of the diagnostic...
-
Running Slope of Ramps Deployed to Roadways or Curb-Height Bus Stops
The Board’s proposed 1:6 maximum ramp slope engendered the largest volume of comments of any of the proposed regulatory changes in the 2010 NPRM....
-
(1) Adjustability: Minimum High Transfer Height
In the preamble to the MDE NPRM, the Access Board sought comment in question 14 on whether the final rule should require an adjustable height range of 17 inches to 25 inches; whether equipment...
-
9. Broadening of Documentation Requirement for Undue Burden Exception
In the 2010 ANPRM, the Access Board proposed to broaden the undue burden documentation requirement so that it applied not only to ICT procurement, but also to other situations in which the...
-
M301.2.3 Size (Section-by-Section Analysis)
The MDE NPRM proposed a transfer surface size for diagnostic equipment used in the supine, prone, or side-lying position of 30 inches wide and 15 inches deep minimum....
-
M304.2.2 Standing Supports (Section-by-Section Analysis)
The MDE NPRM proposed requiring standing supports on each side of the standing surface of diagnostic equipment used by patients in the standing position, and compliance with the technical...
-
2. Accessibility Technical Standard
Many of their comments for additions and revised wording were based on the Access Board's advance notices of proposed rulemaking for the Section 508 update (40) and on success criteria...
-
6.2. Scoping Requirements
In the 2014 NPRM, the Department proposed scoping requirements for captioning devices based on the number of seats in a movie theater. ...
-
5.7.1 Lift Compatibility Clearance in Base for M301
The proposed clearance in the base provision allows the legs of a portable floor lift to fit under the base of the equipment....
-
T207 Circulation Paths
As a matter of clarification, the proposed rule specified that, where doorways are provided on one side of a non-rail vehicle, an accessible circulation path must connect each wheelchair...
-
Comments
Almost all comments from the disability community supported codifying the DLCC, for the reasons described in the NPRM....
-
M302.4 Lift Compatibility (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients in the seated position be usable with a patient lift and comply with either the proposed clearance in base (proposed...
-
E202.4 Functions Located in Maintenance or Monitoring Spaces (Section-by-Section Analysis)
E202.4 Functions Located in Maintenance or Monitoring Spaces (Section-by-Section Analysis) This section proposes to revise § 1194.3(f) of the existing 508 Standards to clarify that, where...
-
Alterations. (Section-by-Section Analysis)
The NPRM proposed at § 35.152(c) that ‘‘[a]lterations to jails, prisons, and other detention and correctional facilities will comply with the requirements of § 35.151(b).'' 73 FR 34466,...
-
R101 Purpose (Section-by-Section Analysis)
R101 Purpose (Section-by-Section Analysis) The proposed guidelines contain scoping and technical requirements to ensure that facilities for pedestrian circulation and use located in the...
-
Automated Airport Kiosk Definition and Applicability Based on Function/Location
automated ticket scanners for rebooking flights during irregular operations were included in the definition of automated kiosks we intended to cover in the rulemaking....
-
M303.2.2 Width (Section-by-Section Analysis)
The MDE NPRM proposed to require that diagnostic equipment used by patients seated in a wheelchair provide a wheelchair space that was at least 36 inches wide....
-
M101.6 Dimensional Tolerances (Section-by-Section Analysis)
The MDE NPRM proposed that dimensions were to be subject to conventional industry tolerances for manufacturing processes, material properties, and field conditions....
-
5.1 Transfer Surface Height Recommendations
NPRM Proposed Provision: M301.2.1 and M302.2.1 Height....