(A) When the cost of alterations necessary to make the path of travel to the altered area fully accessible is disproportionate to the cost of the overall alteration, the path of travel shall...
Search Results "Adjusted Construction Cost"
Commonly Searched Documents
-
§ 35.151(b)(4)(iv)(A)
-
LIMITATION ON BARRIER REMOVAL OBLIGATIONS
the extent that relevant standards for alterations are not provided in subpart D of this part, then the requirements of §36.304 shall not be interpreted to exceed the standards for new construction...
-
Engineered Wood Fiber
The EWF ranged in cost from $ .74/sq. ft. to $2.50/sq. ft. ...
-
Scope: ADA Standard Section 201.1
Section 201 discusses the scope of the ADA Standards.
-
STEP 4: MAKE SURE THAT THE FACILITY IS BEING BUILT ACCORDING TO THE ADA REQUIREMENTS AS SHOWN IN THE BUILDING PLANS.
While most ADA mistakes occur in the building design, many occur during the construction process....
-
Hybrid Surface Systems
The HYB surface systems ranged in cost from $7.50/sq. ft. to $12.65/sq. ft....
-
§35.151(c)
Design, construction, or alteration of facilities in conformance with the Uniform Federal Accessibility Standards (UFAS) (Appendix A to 41 CFR Part 101-19.6) or with the Americans with Disabilities...
-
F244.3 Outdoor Constructed Features in Common Use and Public Use Areas
This section contains the scoping requirements for outdoor constructed features provided in common use and public use areas that serve camping units with mobility features....
-
F245.3 Outdoor Constructed Features in Common Use and Public Use Areas
This section contains the scoping requirements for outdoor constructed features provided in common use and public use areas that serve picnic units with mobility features....
-
5.1.4 Transfer Surface Height Measurement for M301 and M302
5.1.4 Transfer Surface Height Measurement for M301 and M302 The Committee recommends capturing the transfer surface height at the highest point of the seat in an uncompressed...
-
5.1 Transfer Surface Height
5.1 Transfer Surface Height
-
5.1.4 Transfer Surface Height Measurement
5.1.4 Transfer Surface Height Measurement. The transfer surface height should be measured from the floor to the highest point on the seat in an uncompressed state, inclusive of...
-
§8.32(e)
e) Except as otherwise provided in this paragraph, the provisions of §§8.21(a) and (b), 8.22(a) and (b), 8.23, 8.25(a)(1) and (2), and 8.29 shall apply to facilities that are designed, constructed...
-
6.13 Outdoor Constructed Features
Where provided on circulation paths or beach access routes at beaches, outdoor constructed features such as picnic tables, grills or water hydrants, shall comply with technical provisions...
-
§ 35.151(c)(5)(i)
(i) Newly constructed or altered facilities or elements covered by §§35.151(a) or (b) that were constructed or altered before March 15, 2012, and that do not comply with the 1991 Standards...
- National Association of Home Builders (NAHB)
-
Where Platform Lifts are Permitted [§206.7]
In new construction, platform lifts can be used to provide an accessible route to these areas only: wheelchair spaces, performance areas, and speakers’ platforms incidental...
-
Transfer Protocols
The first platform was adjusted to be level with the participant’s WMD seat height....
-
1.1 Conditions for an Exception
Where compliance with the technical provision cannot be accomplished with the prevailing construction practices. Condition for an Exception 3....
- Smith System Flex Single-Student Desk with Hard Plastic Top - 01369
- Smith System Planner Access Station 24″ Deep Table
- Smith System Flex Single-Student Desk 01368 & 01371
- Smith System Husky Round Activity Table
- Smith System Husky Rectangle Activity Table 24″ Deep