An entity shall adopt procedures that incorporate appropriate due process standards and provide for the prompt and equitable resolution of complaints alleging any action prohibited by this...
Search Results "FTDS: Federal Trail Data Standards"
Filters
Commonly Searched Documents
-
§ 37.17(b) Adoption of complaint procedures
-
§ 35.151(g)(2)
(2) Assembly areas that are required to horizontally disperse wheelchair spaces and companion seats by section 221.2.3.1 of the 2010 Standards and have seating encircling, in whole or in...
-
11B-703.5.7 Stroke thickness
[2010 ADA Standards] 703.5.7 Stroke Thickness. Stroke thickness of the uppercase letter "I" shall be 10 percent minimum and 30 percent maximum of the height of the character....
-
11B-806.3.1 Alarms
[2010 ADA Standards] 806.3.1 Alarms. Where emergency warning systems are provided, alarms complying with 702 shall be provided....
-
Plan 3B: 12-Foot Wide Accessible Guest Room
Plan 3B: 12-Foot Wide Accessible Guest Room This drawing shows an accessible 12-foot wide guest room with features that comply with the 2010 Standards....
-
Plan 2A: 13-Foot Wide Accessible Guest Room
Plan 2A: 13-Foot Wide Accessible Guest Room This drawing shows an accessible 13-foot wide guest room with features that comply with the 2010 Standards....
-
M101.2 Application (Section-by-Section Analysis)
In the NPRM the Access Board proposed that the MDE Standards would be applied to diagnostic equipment based on the patient position the equipment is designed to support....
-
BACKGROUND
The proposed technical criteria originated from provisions for grab bars in the 2010 Standards....
-
Regulatory Process Matters
The Department's initial regulatory impact analysis measures the incremental benefits and costs of the proposed standards relative to the benefits and costs of the 1991 Standards. ...
-
Maintenance of Accessible Features
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
Regulatory Process Matters
The Department's initial regulatory impact analysis measures the incremental benefits and costs of the proposed standards relative to the benefits and costs of the 1991 Standards. ...
-
11B-502.7.1 Arrangement
. ◼ ETA Editor's Note While 2010 ADA Standards Advisory 502.3 discourages configuring access aisles to require travel behind other parked vehicles, CBC 11B-502.7.1 prohibits this...
-
11B-216.3 Directional and informational signs
[2010 ADA Standards] 216.3 Directional and Informational Signs....
-
STORY
[2010 ADA Standards 106.5] Story....
-
11B-705.1.1.3.2
[2010 ADA Standards] 705.1.3 Contrast. Detectable warning surfaces shall contrast visually with adjacent walking surfaces either light-on-dark, or dark-on-light. ...
-
11B-606.3 Height
[2010 ADA Standards] 1....
-
Nuance Power PDF with RMS Security
Until recently the standard practice was to use password protection to allow or deny access to your document or limit functionality....
-
ADA25: #1 of 25 -- The NAD and the ADA
It was a great step forward but limited in that it only applies to federal agencies, or private entities receiving federal funding....
-
ADA25: #3 of 25 -- Title I
Title I covers state/local employers, but not federal employers. Federal employers are covered under a different law....
-
ADA25: #5 of 25 -- Title III
Federal agency responsible for ensuring compliance with Title III is the U.S. Department of Justice. They have several duties when it comes to monitoring compliance with Title III....
-
Norton Surface Mounted 5700 Series Low Energy Door Operator
inverter damage Motor Start Delay for Locking Hardware - 0-5 second delay to allow locking hardware to release first Onboard power supply for accessories: 24VDC (1.1A) Electrical Data...
-
Norton Surface Mounted 5900 Series Low Energy Door Operator
Selector mode switch (3 position) – Off - disables signal inputs – On - activates signal inputs – Hold Open - activates the unit to the hold open position Electrical Data...
-
810.9 Escalators
Where provided, escalators shall comply with the sections 6.1.3.5.6 and 6.1.3.6.5 of ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1) and shall have a clear...
-
F207.2 Platform Lifts
1003.2.13.4 of the International Building Code (2000 edition and 2001 Supplement) or section 1007.5 of the International Building Code (2003 edition) (incorporated by reference, see "Referenced Standards...
