would require the clearance in the base to be 44 inches wide minimum, 6 inches high minimum measured from the floor, and 36 inches deep minimum measured from the edge of the examination surface...
Search Results "End Transfer Surface"
Filters
Commonly Searched Documents
-
Clearance in Base (M301.4.1 and M302.4.1)
-
Paragraph (f) Prevention of visually induced seizures (Section-by-Section Analysis)
The Trace Center also suggested the 2 Hz lower end but pointed out that some visual characteristics of video screens, for example, could not achieve that level....
-
7. Training Call Takers to Respond Effectively to TTY Calls
Some Helpful TTY Abbreviations GA: go ahead,your turn to talk GA or SK: go ahead, or goodbye, or stop keying SKSK: stop keying, end of...
-
11B-221.2.3.2 Vertical dispersion
The lower rows of bleacher seats in a bank of bleachers often are omitted to allow for wheelchair positions with companion seating provided on the end of the adjacent row or on portable...
-
Outdoor Rinsing Showers [1011.2, 1011.3, and 1011.7]
The shower pedestal or wall with the shower heads must be at the rear end of the clear ground space. At least one hand-held shower spray unit must be provided....
-
402.2 Speech-Output Enabled (Section-by-Section Analysis)
interpreted as requiring ICT with closed functionality to provide speech output since that is the only means of making such products “usable by people with disabilities without requiring an end-user...
-
MISCELLANEOUS PROVISIONS
At the end of that period, the City will submit a copy of its training curriculum and materials to the Department, along with a list of employees trained and the name, title, and address...
-
Study Limitations
At the other end, twenty-two user types had one user each. Much of the following discussion focuses on user types for which five or more users were observed in this study....
-
Section 36.204 Administrative Methods (Section-By-Section Analysis and Response to Comments)
Both sections incorporate a disparate impact standard to ensure the effectiveness of the legislative mandate to end discrimination....
-
11B-221.2.3.2 Vertical dispersion
The lower rows of bleacher seats in a bank of bleachers often are omitted to allow for wheelchair positions with companion seating provided on the end of the adjacent row or on portable...
-
11B-221.2.3.2 Vertical dispersion
The lower rows of bleacher seats in a bank of bleachers often are omitted to allow for wheelchair positions with companion seating provided on the end of the adjacent row or on portable...
-
1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (865 mm) maximum above the ground or deck surface....
-
403.5.1 Clear Width
Except as provided in 403.5.2 and 403.5.3, the clear width of walking surfaces shall be 36 inches (915 mm) minimum....
-
1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (865 mm) maximum above the ground or deck surface....
-
R406.3 Unobstructed Side Reach
approach to an element and the side reach is unobstructed, the high side reach shall be 1220 mm (4.0 ft) maximum and the low side reach shall be 380 mm (1.25 ft) minimum above the finish surface...
-
Built-up Curb Ramps [4.7.6]
(The surface of access aisles cannot slope more than 2% in any direction)....
-
4.1.7(3)(e)
., open books), should be no higher than 44 in (1120 mm) above the floor surface....
-
4.7.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
Wheelchair Work Measurement Method
Wheelchair work per meter values for straight and turning were determined for all test course surfaces except sand, under dry conditions using the Wheelchair Work Measurement Method in accordance...
-
Fixed tactile maps
Placement on a horizontal or near horizontal surface provides the map reader with a real world orientation....
-
6.9 Tread Obstacles
Where the surface is paved or is elevated above the natural ground, obstacles shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
Original research for ANSI A117.1 (1957 - 1961)
Buildings and Facilities Accessible to, and Usable by, the Physically Handicapped, ramps were assessed for flatness based on measuring 18 - inch increments on both edges of the ramped surface...
-
11B-704.5 TTY shelf
The telephone handset shall be capable of being placed flush on the surface of the shelf....
-
D. Department of Justice Activities Related to Health Care Providers and Medical Equipment
includes information on accessible examination rooms and the clear floor space needed adjacent to medical equipment for individuals who use mobility devices to approach the equipment for transfer...