Designed according to the ADA Standards for Accessible Design, All Access offers elevated viewing platforms featuring ramps and guardrails that can easily work with your current venue design...
Search Results "Designated Agency"
Commonly Searched Documents
- All Access, Inc. ADA Platforms
- Section 508.gov
- The Accessibility Management Platform (AMP) - AMP for Mobile
- Department of Labor, Office of Disability Employment Policy (ODEP)
-
Establishing Disability History Awareness Initiatives – A Roadmap for States & Territories
This document is designed to assist states that have not yet passed legislation related to Disability History Awareness....
- Disabled Community
- Independence Now, Inc. - Silver Spring, MD
- ADA Fast Finder
- MOCEANS Center for Independent Living, Inc. - Long Branch and Toms River, NJ
- National Safety Council (NSC)
-
II. Recommendations of Diagnostic Imaging Equipment Manufacturers on Transfer Surface Low Height
Complete scanner re-testing and re-certification under our formal FDA quality system and design controls are needed to verify overall system performance and safety....
-
Whether the definition of ‘‘wheelchair'' includes the Segway® PT. (Section-by-Section Analysis)
The fact that the Segway® PT is not designed primarily for use by individuals with disabilities, nor used primarily by persons with disabilities, complicates the question of to what extent...
-
§ 382.38 Seating accommodations
(2) The carrier may designate an adequate number of the seats used to provide seating accommodations required by this section as "priority seats" for individuals with disabilities....
-
XI. Overview of Americans with Disabilities Act Accessibility Guidelines for New Construction and Alterations
The Guidelines contain general design ("technical") standards for building and site elements, such as parking, accessible routes, ramps, stairs, elevators, doors, entrances, drinking fountains...
-
Common Use Circulation Paths in Employee Work Areas
The 1991 Standards at section 4.1.1(3), and the 2010 Standards at section 203.9, require employee work areas in new construction and alterations only to be designed and constructed so that...
-
Meeting ANSI Standard S12.60 Requirements
Designing a classroom to meet the acoustical requirements of the ANSI standard is neither difficult nor costly....
-
c) Aquatic Program
The three pools Kirola complained about were not designated as accessible at the time of trial. However, program access does not require the City to make every pool accessible....
-
A MINIMUM HIGHEST POINT STANDARD OF 19 INCHES IS CONSISTENT WITH EXISTING ACCESSIBILITY STANDARDS
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area.16 As...
-
Section 36.406(d) Social Service Establishments (Section-by-Section Analysis)
The two design standards for accessibility (i.e., the 1991 Standards and UFAS) have confronted many social service providers with separate, sometimes conflicting requirements for the design...
-
Section 35.151(e) Social Service Establishments (Section-by-Section Analysis)
The two design standards for accessibility--i.e., the 1991 Standards and UFAS--have confronted many social service providers with separate, and sometimes conflicting, requirements for design...
-
Other Power-driven Mobility Devices (OPDMDs)
type, size, weight, dimensions, and speed of the device; volume of pedestrian traffic (which may vary at different times of the day, week, month, or year); the facility's design...
-
Slopes and Resting Intervals for Outdoor Recreation Access Routes
Design Tip The cross slope requirement depends on what material is used. Those who use a mobility device know that as cross slope increases, travel becomes more difficult....
-
BACKGROUND
The Board then designates them as "accessible," which indicates compliance with State guidelines, or "not fully accessible."...
-
Accessibility - Flatness and Lippage
Because the flatness of wood and concrete substrates can change over time, it is recommended that the designer make provisions for evaluating substrate flatness just before installation...