The slope of a resting interval shall not exceed 1:20 (5 percent) in any direction....
Search Results "Shall"
Commonly Searched Documents
-
7.4.4.3 Slope
-
4.21.7 CURBS
If provided, curbs in shower stalls 36 in by 36 in (915 mm by 915 mm) shall be no higher than 1/2 in (13 mm)....
-
3.1.3.1 Slope of Vehicle Parking Areas
The slope of vehicle parking areas shall not exceed 1:48 (2 percent) in any direction. Exception....
-
6.6 Clear Width
The clear width of beach access routes shall be 60 inches (1525 mm) minimum....
-
6.7.2 Cross Slope
The cross slope of a beach access route shall be no more than 1:33 (3 percent)....
-
8.4 CARD CATALOGS
Minimum clear aisle space at card catalogs, magazine displays, or reference stacks shall comply with Fig. 55....
-
2.5.4 Slope
Resting intervals shall not be steeper than 1:33 (3 percent) in any direction....
-
1018.4 Clear Width
The clear width of beach access routes shall be 60 inches (1525 mm) minimum....
-
M302.3.3 Head and Back Support
Where the diagnostic equipment is used in a reclined position, head and back support shall be provided....
-
M301.3.3 Head and Back Support
Where the diagnostic equipment is used in a reclined position, head and back support shall be provided....
-
§ 35.171(c)(2)
(2) If the designated agency receives a complaint that is not complete, it shall notify the complainant and specify the additional information that is needed to make the complaint a complete...
-
1132A.10 Door signal devices
Every primary entrance to a covered multifamily dwelling unit shall be provided with a door buzzer, bell, chime or equivalent....
-
11B-1009.5.6 Size
Each transfer step shall have a tread clear depth of 14 inches (356 mm) minimum and 17 inches (432 mm) maximum and shall have a tread clear width of 24 inches (610 mm) minimum....
-
11B-306.2.2 Maximum depth
Toe clearance shall extend 25 inches (635 mm) maximum under an element....
-
1134A.7, Item 4
Water closet controls shall be mounted no more than 44 inches (1118 mm) above the floor. The force required to activate controls shall be no greater than 5 pounds (22.2 N)....
-
11B-411.2.1.4.1.2 Identification
Buttons shall be identified by raised characters and symbols, white on a black background, complying with Section 11B-703.2 and Braille complying with Section 11B-703.3....
-
§ 35.172(c)
(c) Where appropriate, the designated agency shall attempt informal resolution of any matter being investigated under this section, and, if resolution is not achieved and a violation is...
-
11B-604.1 General
Water closets and toilet compartments shall comply with Sections 11B-604.2 through 11B-604.8....
-
11B-903.6 Structural strength
Benches shall be affixed to the wall or floor....
-
11B-703.8.6 Stroke width
The uppercase letter “I” shall be used to determine the allowable stroke width of all low resolution VMS characters of a font....
-
11B-306.2.2 Maximum depth
Toe clearance shall extend 25 inches (635 mm) maximum under an element....
-
11B-411.2.1.4.1.2 Identification
Buttons shall be identified by raised characters and symbols, white on a black background, complying with Section 11B-703.2 and Braille complying with Section 11B-703.3....
-
11B-1009.5.6 Size
Each transfer step shall have a tread clear depth of 14 inches (356 mm) minimum and 17 inches (432 mm) maximum and shall have a tread clear width of 24 inches (610 mm) minimum....
-
1132A.10 Door signal devices
Every primary entrance to a covered multifamily dwelling unit shall be provided with a door buzzer, bell, chime or equivalent....