In Group B and M occupancies, the minimum clear aisle width shall be determined by Section 1005.1 for the occupant load served, but shall not be less than that required for corridors by...
Search Results "Supplemental Requirement"
Filters
Commonly Searched Documents
-
1018.3 Aisles in Groups B and M
-
11B-204.1 General
Within areas of sport activity, protruding objects on circulation paths shall not be required to comply with Section 11B-307. 2....
-
11B-812.5.4 Arrangement
Vehicle spaces and access aisles shall be designed so that persons using them are not required to travel behind vehicle spaces or parking spaces other than the vehicle space in which their...
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area at the exterior side of the primary entry door and any required exit doors shall comply with Section 1126A....
-
1009.3.2 Stairway width
Exceptions: The clear width of 48 inches (1219 mm) between handrails is not required in buildings equipped throughout with an automatic sprinkler system installed in accordance with...
-
Accessible Routes from Site Arrival Points and Within Sites
The 1991 Standards require that curb ramps be provided wherever an accessible route crosses a curb....
-
Historic Preservation Programs
Narrow application of the special limitation is justified because of the inherent flexibility of the program accessibility requirement....
-
Examples and Resources to Support Criminal Justice Entities in Compliance with Title II of the ADA
this guidance discusses are restatements of existing requirements from Title II of the Americans with Disabilities Act, 42 USC 12131-12134, and its implementing regulations at 28 CFR pt...
-
Section 610 Review
The Department also is required to conduct a periodic regulatory review pursuant to section 610 of the RFA, as amended by the SBREFA....
-
407.12 Reach Height (Section-by-Section Analysis)
407.12 Reach Height (Section-by-Section Analysis) This section proposes requirements for the height of side and forward reaches that would enable persons using wheelchairs or other mobility...
-
410.6 Real-Time Text Functionality (Section-by-Section Analysis)
Proposed 410.6 would require that, where ICT supports real-time voice communication, it must also support RTT functionality....
-
About this Guide
This guide explains requirements of both standards, which are jointly referred to as the “ADA Standards” or “the standards.”...
-
M304 Diagnostic Equipment Used by Patients in Standing Position
The proposed standards do not require diagnostic equipment to support more than one position....
-
Section 610 Review
The Department is also required to conduct a periodic regulatory review pursuant to section 610 of the RFA....
-
Communication. (Section-by-Section Analysis)
Several large disability advocacy organizations commented on the 2004 ADAAG section 232.2.2 requirement that at least 2 percent of the general holding cells and housing cells must be equipped...
-
11B-604.3.2 Overlap
routes, clear floor space and clearances required at other fixtures, and the turning space....
-
11B-604.3.2 Overlap
routes, clear floor space and clearances required at other fixtures, and the turning space....
-
11B-224.7.2 Multi-bedroom housing units with adaptable features
Multi-bedroom housing units with adaptable features shall be provided as required by Section 11B-233.3.1.2....
-
ADA OBLIGATIONS AND ACTIONS TO BE TAKEN BY THE CITY AND PPD
In some circumstances, oral communication supplemented by gestures and visual aids, an exchange of written notes, use of a computer, or use of an assistive listening device may be effective...
-
F216.2 Designations
EXCEPTION: Exterior signs that are not located at the door to the space they serve shall not be required to comply with 703.2. Advisory F216.2 Designations....
-
Section 35.151(b)(3) Alterations to historic facilities
Section 35.151(b)(3) Alterations to historic facilities The final rule renumbers the requirements for alterations to historic facilities enumerated in current Sec. 35.151(d)(1) and (2...
-
Section 1193.1 Purpose (Section-by-Section Analysis)
Section 255 (b) of the Act requires that manufacturers of telecommunications equipment or customer premises equipment shall ensure that the equipment is designed, developed, and fabricated...
-
Signs
Section 216.10 of the 2010 Standards requires each covered assembly area to provide signs at each auditorium to inform patrons that assistive listening systems are available....
-
"Housing at a place of education" definition
The Department has added a new definition to Sec. 35.104, “Housing at a Place of Education,’’ and has revised Sec. 35.151(f) to reflect the accessible features that now will be required...