35.104: "Wheelchair means a device designed solely for use by an individual with a mobility impairment for the primary purpose of locomotion in typical indoor and outdoor pedestrian areas...
Search Results "Sloped Area"
-
"Wheelchair" (Section-by-Section Analysis)
-
Section 4.1.3, Accessible Buildings: New Construction (Section-By-Section Analysis and Response to Comments)
ADAAG Section 4.1.3(9), with accompanying technical requirements in Section 4.3, requires an area of rescue assistance (i.e., an area with direct access to an exit stairway and where people...
-
II-5.1000 General
The city is not required to make all areas in the building accessible, as long as the meeting room is accessible....
-
Scales
Accessible Scale 1.Sloped surface provides access to scale platform -- no abrupt level changes at floor or platform. 2.Edge protection at drop off. 3.Large platform to accommodates...
-
Boating facilities. (Section-by-Section Analysis)
attached to land) are involved, a number of exceptions are provided from the general standards for accessible routes in order to take into account the difficulty of meeting accessibility slope...
-
OTHER SPECIFIC BARRIERS
Some of the barriers identified in Exhibit A are so severe that they constitute safety hazards to persons with mobility disabilities, including curb ramps with running slopes greater than...
-
Boating facilities. (Section-by-Section Analysis)
attached to land) are involved, a number of exceptions are provided from the general standards for accessible routes in order to take into account the difficulty of meeting accessibility slope...
-
407.12.3.2.2 Knee and Toe Space (Section-by-Section Analysis)
Building on this exception, the second exception would allow further reduction in the height of the space along the profile of the knee to the toe sloping at 6:1 toward the maximum protrusion...
-
4.9.4 HANDRAILS
At the bottom, the handrail shall continue to slope for a distance of the width of one tread from the bottom riser; the remainder of the extension shall be horizontal (see Fig. 19(c) and...
-
Standardized Tests of Physical Fitness and Community Ambulation
Perceived difficulty was designed to consider factors such as the security of footing, obstacle negotiation, and effort required on slopes....
-
11B-233.3.1.2.6.1 Single building with one common (lobby) entrance
Test No. 1 -- Individual Building Test may only be used if the site has terrain over 15 percent slope. Test No. 3 -- Unusual Characteristics Test may be used if applicable....
-
3. Camera
Consider taking additional photos of the digital level showing slope and cross slope measurements of walkways and ramps as well as photos showing exactly where the digital level was placed...
-
Clear Ground Space [1011.2]
The technical requirements include specific provisions for the size, location, surface, slope, and openings in the clear ground space....
-
A) Accessible Parking
Access aisle of at least 60-inch width must be level (1:50 maximum slope in all directions), be the same length as the adjacent parking space(s) it serves and must connect to an accessible...
-
1630.2(j)(3)(II)(C)
individual has been disqualified because of an impairment, and the number and types of other jobs not utilizing similar training, knowledge, skills or abilities, within that geographical area...
-
WALK
[DSA-AC] An exterior prepared surface for pedestrian use, including pedestrian areas such as plazas and courts. (As differentiated from the definition of “Sidewalk”.)...
-
Can handrail extensions wrap or turn?
Extensions are not required for continuous handrails along switchback or dogleg ramps or at aisle ramps serving seating in assembly areas....
-
11B-608.1 General
Shower stalls that are 60 inches (1525 mm) wide and have no curb may increase the usability of a bathroom because the shower area provides additional maneuvering space....
-
802.1.2 Width
Figure 802.1.2 Width of Wheelchair Spaces in Assembly Areas...
-
505.3 Continuity
EXCEPTION: In assembly areas, handrails on ramps shall not be required to be continuous in aisles serving seating....
-
804.2.2 U-Shaped
In U-shaped kitchens enclosed on three contiguous sides, clearance between all opposing base cabinets, counter tops, appliances, or walls within kitchen work areas shall be 60 inches (1525...
-
II. Rulemaking History
The 2007 draft also proposed to decrease the maximum running slope of vehicle ramps to 1:8 (as compared to the existing guidelines, which specify a range of ramp slopes from 1:4 to 1:12,...
-
Assistive Listening Systems
In the final rule, the Board has added an exception for assembly areas where all seats are served by an induction loop system (219.3, Exception 2)....
-
Reduced scoping for public accommodations, small facilities, and qualified small businesses. (Section-by-Section Analysis)
Department's initial regulatory assessment, the Department has identified ten elements for which the Department believes reduced scoping might be appropriate for barrier removal: play areas...