for purposes of section 12132 of this title and section 794 of title 29 for a person to remanufacture a rail passenger car for use in intercity or commuter rail transportation so as to extend...
Search Results "Extended Floor Surface"
-
12162(d)(1) Remanufacturing
-
A4.2.1(2) Space Requirements for Use of Walking Aids
Crutch tips, often extending down at a wide angle, are a hazard in narrow passageways where they might not be seen by other pedestrians....
-
A4.2.1(2) Space Requirements for Use of Walking Aids
Crutch tips, often extending down at a wide angle, are a hazard in narrow passageways where they might not be seen by other pedestrians....
-
Knee Clearance: Clearance as Measured from Distal Knee Point - Manual Wheelchair
Hence, to accommodate a particular percentage of users, the side profile of a design element (shown by dotted line) should not extend outside the corresponding shaded area....
-
1015.3 Viewing Space
The viewing space is required to be 32 inches maximum and 51 inches minimum high above the ground and extend the full width of the clear ground space....
-
Knee Clearance: Clearance as Measured from Anterior-Most Abdomen Point - Manual Wheelchair
Hence, to accommodate a particular percentage of users, the side profile of a design element (shown by dotted line) should not extend outside the corresponding shaded area....
-
4. Passenger Vessels
That comment period was extended to January 24, 2014. Once finalized, these guidelines will supplement the Board’s ADA Accessibility Guidelines for Transportation Vehicles....
-
Seton Directional Entrance Sign - Left Arrow
Use Accessible Entrance Signs to direct users to the nearest accessible entrance Engineer Grade reflective .063" aluminum material is equally visible day or night Extend the life...
-
805 Medical Care and Long-Term Care Facilities
Revisions made to this section include: removing a stipulation that wheelchair turning space not extend beneath beds (805.2) clarifying fixture requirements in accessible...
-
The Americans with Disabilities Act Comprehensive Civil Rights Legislation
Nondiscrimination in Public Accommodations Title III of the ADA extends to people with disabilities the same protections that Title II of the Civil Rights Act of 1964 extends to people...
-
II-1.1000 General
It additionally extends the prohibition of discrimination on the basis of disability established by section 504 of the Rehabilitation Act of 1973, as amended, to all activities of State...
-
Check-out Aisle Counter Height
The counter surface of check-out aisle counters is required to be 38 inches high maximum. Comments from persons with disabilities considered 38 inches to be too high. Response....
-
Delimitations
following: Data from this study were obtained from a longitudinal study administered through the National Center on Accessibility (NCA) at Indiana University; One category of surface...
-
Recommendations for Further Action
are available for use on pedestrian trails and how various surface materials perform in different regions of the country....
-
Tactile Symbols: ADA Standard Section 707.6.3.2
Function key surfaces shall have tactile symbols as follows: Enter or Proceed key: raised circle; Clear or Correct key: raised left arrow; Cancel key: raised letter ex; Add Value key: raised...
-
Dome Size: ADA Standard Section 705.1.1
Truncated domes in a detectable warning surface shall have a base diameter of 0.9 inch (23 mm) minimum and 1.4 inches (36 mm) maximum, a top diameter of 50 percent of the base diameter minimum...
-
11B-707.6.3.2 Tactile symbols
Function key surfaces shall have tactile symbols as follows: Enter or Proceed key: raised circle; Clear or Correct key: raised left arrow; Cancel key: raised letter ex; Add Value key: raised...
-
11B-411.2.1.5.1 Size
Buttons shall have square shoulders, be 3/4 inch (19.1 mm) minimum in the smallest dimension and shall be raised 1/8 inch (3.2 mm) plus or minus 1/32 inch (0.8 mm) above the surrounding surface...
-
11B-707.6.3.2 Tactile symbols
Function key surfaces shall have tactile symbols as follows: Enter or Proceed key: raised circle; Clear or Correct key: raised left arrow; Cancel key: raised letter ex; Add Value key: raised...
-
11B-411.2.1.5.1 Size
Buttons shall have square shoulders, be 3/4 inch (19.1 mm) minimum in the smallest dimension and shall be raised 1/8 inch (3.2 mm) plus or minus 1/32 inch (0.8 mm) above the surrounding surface...
-
APPENDIX B
OUTSIDE SURFACES Figure 27: Pictures and Roughness Index of Outside surfaces...
-
406.2 Counter Slope
Counter slopes of adjoining gutters and road surfaces immediately adjacent to the curb ramp shall not be steeper than 1:20....
-
Unobstructed: ADA Standard Section 308.2.1
Section 308.2.1 covers the current ADA Standards for unobstructed forward reach.
-
Coat Hooks and Shelves: ADA Standard Section 604.8.3
Section 604.8.3 covers the current ADA Standards for coat hooks and shelves in an ambulatory accessible compartment.
