(1) To the extent that it is readily achievable, a public accommodation in assembly areas shall --...
Search Results "Commercial Place of Public Amusement"
Filters
Commonly Searched Documents
-
Sec.36.308(a)(1)
-
F216.9 TTYs
Identification and directional signs for public TTYs shall be provided in accordance with F216.9....
-
F216.9.1 Identification Signs
Public TTYs shall be identified by the International Symbol of TTY complying with 703.7.2.2....
-
Sec.36.603(c)(3)
(3) A transcript of the public hearing required by paragraph (b)(3) of this section; and...
-
217.3 Volume Controls
All public telephones shall have volume controls complying with 704.3....
-
216.9 TTYs
Identification and directional signs for public TTYs shall be provided in accordance with 216.9....
-
Private entity
Private entity means a person or entity other than a public entity....
-
§35.173(a)(2)
(2) Initiate negotiations with the public entity to secure compliance by voluntary means....
-
1.1.3.2, Item 14.5
Public school automatic fire detection, alarm, and sprinkler systems....
-
Private entity
Private entity means a person or entity other than a public entity....
-
216.9.1 Identification Signs
Public TTYs shall be identified by the International Symbol of TTY complying with 703.7.2.2....
-
§ 35.173(a)(2)
(2) Initiate negotiations with the public entity to secure compliance by voluntary means....
-
§ 37.147(e)
(e) Whether the entity complied with the public participation efforts required by this part; and...
-
§ 37.7(b)(2)(v)
(v) Documentation of the public participation used in developing an alternative method of compliance....
-
§ 37.3 Private entity
Private entity means any entity other than a public entity....
-
§ 37.9(d)(2)(v)
(v) Documentation of the public participation used in developing an alternative method of compliance....
-
Feature 3 - Building Entrance
The accessible entrance must remain unlocked when the meeting is taking place. ADA Standards for Accessible Design | Temporary Barrier Removal Suggestions for Accessible Features...
-
11B-705.1.2.2 Curb ramps
Exception: On parallel curb ramps, detectable warnings shall be placed on the turning space at the flush transition between the street and sidewalk....
-
Accessible Check-out Aisle Signage
The proposed rule required that this identification be placed in the same location as the identifying number or type of check-out aisle....
-
M304.2 Standing Surface (Section-by-Section Analysis)
In preparing the final rule, the Board has determined that as previously drafted this provision unintentionally placed requirements on the facility floor, as opposed to restricting the requirements...
-
604.3.2 Overlap
When the door to the toilet room is placed directly in front of the water closet, the water closet cannot overlap the required maneuvering clearance for the door inside the room....
-
604.8.1.2 Doors
A door pull complying with 404.2.7 shall be placed on both sides of the door near the latch. Toilet compartment doors shall not swing into the minimum required compartment area....
-
Surface, Slope, and Openings [1011.2.2, 1011.2.3, and 1011.2.4]
Where possible, drainage grates should be located outside the clear ground space and elongated openings should be placed perpendicular, or as close to perpendicular as possible, to the dominant...