These guidelines establish minimum accessibility requirements to provide a general level of usability for people with disabilities....
Search Results "Floor-Level Exit Sign"
Commonly Searched Documents
-
Chapter 1: Background
-
Elevator Operable Parts
The proposed rule specified that call buttons be located 35 to 48 inches above the floor (407.2.2)....
-
A4.1.3(10)
A4.1.3(10) If an odd number of drinking fountains is provided on a floor, the requirement in 4.1.3(10)(b) may be met by rounding down the odd number to an even number and calculating 50%...
-
11B-308.3.1 Unobstructed
Where a clear floor or ground space allows a parallel approach to an element and the side reach is unobstructed, the high side reach shall be 48 inches (1219 mm) maximum and the low side...
-
403 Walking Surfaces
The requirements for walking surfaces derive from existing specifications for accessible routes covering floor or ground surfaces, slope, changes in level, and clearances....
-
What other considerations are significant for persons with disabilities?
ADAAG also contains provisions that limit surface discontinuities along an accessible route, including elevator cab leveling tolerances at landings, gaps between car and platform in transit...
- Power PDF and Electronic Signatures
-
1009.3.2 Submerged Depth
Sloped entries shall extend to a depth of 24 inches (610 mm) minimum and 30 inches (760 mm) maximum below the stationary water level....
-
Mono Jacks, Sound Pressure, Etc
The 2010 Standards also specify sound pressure level, signal-to-noise ratio, and peak clipping level....
-
405.7 Landings
Ramps that do not have level landings at changes in direction can create a compound slope that will not meet the requirements of this document....
-
PERSONNEL PREPARATION
Physical activities may be guided by a wide range of support personnel with various levels of training including other students, general and special education teachers, paraprofessionals...
-
Sec. 12144. Public entity operating a demand responsive system. [Section 224]
1990, that is not readily accessible to and usable by individuals with disabilities, including individuals who use wheelchairs, unless such system, when viewed in its entirety, provides a level...
-
C203.1 General (Section-by-Section Analysis)
C203.1 General (Section-by-Section Analysis) The section proposes to require content integral to the use of covered ICT to conform to Level A and Level AA Success Criteria and Conformance...
-
FAQ: What is "My Storage Space?"
Premium-level subscribers may store up to 2GB and Accessibility Specialist-level subscribers may store up to 5GB....
-
11B-406.5.8 Counter slope
The adjacent surfaces at transitions at curb ramps to walks, gutters, and streets shall be at the same level. [2010 ADA Standards] 406.2 Counter Slope....
- FEMA: Office of Disability Integration and Coordination
-
Problem Two (Protruding Objects)
Problem Two: A wall-mounted display case protrudes seven inches from the wall and the bottom of the case is 40 inches above the floor....
-
M. Reach Range
Are the rod and shelf in the clothes closet or wall mounted unit within 54" of the floor for side approach or 48" of the floor for forward approach so persons who use wheelchairs can approach...
-
11B-704.3 Volume control telephones
If a volume adjustment is provided that allows the user to set the level anywhere from the base volume to the upper requirement of 20 dB, there is no need to specify a lower limit....
-
5.7.1 Lift Compatibility Clearance in Base for M301
5.7.1 Lift Compatibility Clearance in Base for M301 Description: For portable floor lifts to be effective, they must deploy at diagnostic equipment such that the boom of the lifts can...
-
Orientation (slide 12)
Floor-plan organization, if it’s consistent from floor to floor, it’s much easier for people to navigate....
-
§ 38.83(c)(5) Slope
If the height of the vehicle floor, under 50% passenger load, from which the ramp is deployed is 3 inches or less above the station platform a maximum slope of 1:4 is permitted; if the height...
-
703.5.5 Character Height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
Signage
Comment and Question by Tom Williams: Along with the discussion about wayfinding and signage, it brings out the issue of contrast and tactile signs and so on....