Section 37.7 Standards for Accessible Vehicles This section makes clear that, in order to meet accessibility requirements of this rule, vehicles must comply with Access Board standards...
Search Results "Door Clear Width"
Commonly Searched Documents
-
Section 37.7 Standards for Accessible Vehicles
-
Toilet Compartments: ADA Standard Section 213.3.1
Section 213.3.1 covers scoping requirements in the current ADA Standards for toilet compartments.
-
Oven Controls
A specification that these controls be to the side of the door has been removed in the final rule as unnecessarily restrictive....
-
Question 17
Are the signs for the accessible restrooms and fitting rooms still readable and mounted next to the latch side of the door, at 5 feet to centerline of the sign?...
-
11B-611.3 Operable parts
Operable parts, including doors, lint screens, and detergent and bleach compartments shall comply with Section 11B-309....
-
§ 38.153(d)
(d) The overhead clearance between the top of the lift door opening and the sill shall be the maximum practicable but not less than 65 inches (1651 mm)....
-
4. Comparison of Proposed Technical Provisions Applicable to Shared Use Paths and AASHTO Guide
A pedestrian access route shall be provided for the full width of a shared use path. 5.2.1 Width and Clearance The minimum paved width for a two-directional shared use...
-
Trailers with Two Wheels
Width and length vary, although the majority are relatively small trailers used for carrying children....
-
5. Accessible Features
interior routes; snow removal on exterior routes; replacing damaged or stolen room identification signs; tightening or adjusting accessible toilet seat fasteners, grab bars, handrails and door...
-
If a more recent edition of ANSI/BHMA Standards for automated doors is issued should that be followed instead of those referenced?
The specific editions of the ANSI/BHMA Standards referenced by the Standards are to be followed (although the Access Board intends to update references to keep them current)....
-
4. Exception from the Requirements of M301 for Certain Examination Chairs that Comply with M302
The Access Board sought public input in question three in the preamble in the MDE NPRM, on whether organizing the technical criteria functionally by patient position was clear. 77 FR at...
-
Trailhead Information Signs [F216.13 and 1017.10]
new trail information signs must include the following information: Length of the trail or trail segment Type of trail surface Typical and minimum trail tread width...
-
Getting From Here to There—Outdoor Recreation Access Routes
Design outdoor recreation access routes to meet technical requirements for running and cross slopes, resting intervals, surface, clear tread width, passing spaces, tread obstacles, protruding...
-
M14
Is the operating control (switch, lever, button, or pull) for each type of dispenser or built-in equipment no higher than 54 inches above the floor (if there is clear floor space for a parallel...
-
4.2.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
R302.7 Surfaces
The surface requirements in R302.7 also apply to surfaces at the following accessible elements and spaces that connect to pedestrian access routes: • Clear spaces (see R404.2), including...
-
1009.9 Signage
Each door providing access to an area of refuge from an adjacent floor area shall be identified by a sign stating: AREA OF REFUGE. 2....
-
§ 38.175(a)
The design of cars shall be coordinated with the boarding platform design such that the horizontal gap between a car door at rest and the platform shall be no greater than 3 inches and the...
- Nova Health Products LiteRamp 6' Wheelchair and Scooter Ramp (LR6)
- Symmetry Vertical Platform Lift VPC-EL
-
Passenger Loading Zones
Commenters raised a variety of issues about the requirements at section 503 of the 2010 Standards stating that the requirements for an access aisle, width, length, and marking of passenger...
-
220 Automatic Teller Machines and Fare Machines
Accessible fare collection devices shall have a minimum clear opening width of 32 inches; shall permit passage of a wheelchair; and, where provided, coin or card slots and controls necessary...
-
Legislation
The ADA states that "physical or mental disabilities in no way diminish a person’s right to fully participate in all aspects of society…" It is a purpose of the ADA "to provide a clear and...
-
407.12.1.2 Vertical Plane for Forward Reach (Section-by-Section Analysis)
The 30-inch dimension is based on the width of a stationary occupied wheelchair....