not readily achievable for a business to provide a fixed lift – that is, if it would be too difficult or expensive to make these changes – then a business may use other ways, such as a non-fixed...
Search Results "Non-Tactile Keypad"
Filters
Commonly Searched Documents
-
6. What if I can’t afford to install a fixed lift in my pool, or it would be difficult to do so?
-
Election Systems & Software AuroMARK Ballot - Marking Devices
The AutoMARK® ballot-marking system provides autonomy to voters who are blind, visually impaired, or have a disability or condition that makes it difficult to traditionally mark a...
-
203 General Exceptions
The 1991 Standards, at section 4.1.1, contain an exception that exempts “non-occupiable” spaces that have limited means of access, such as ladders or very narrow passageways, and that are...
-
Mounting Location and Height [4.30.6]
Mounting Location and Height [4.30.6] Placement of tactile signs aside doors (latch-side) provides safety since locating signs on doors that swing out is hazardous....
-
11B-703.1.1.2 Inspection
Signs and identification devices shall be field inspected after installation and approved by the enforcing agency prior to the issuance of a final certificate of occupancy per...
-
G. Chapter 6: Wheelchair Spaces and Securement Systems
Chapter 6 in the 2016 Non-Rail Vehicle Guidelines establishes technical requirements for wheelchair spaces, wheelchair securement systems, and seat belts and shoulder belts provided for...
-
§27.71(k)(6)(iv)(A) Contrast.
However, tactile symbols required by (k)(6)(iv)(B) are not required to comply with paragraph (k)(6)(iv)(A) of this section....
-
§ 27.71(k)(6)(iv)(A) Contrast
However, tactile symbols required by (k)(6)(iv)(B) are not required to comply with paragraph (k)(6)(iv)(A) of this section....
-
11B-216.1 General
signs identifying permanent rooms and spaces, directional and informational signs (except those relating to accessible means of egress), and entrance signs are not required to comply with tactile...
-
1007.6.5 Identification
Additionally, tactile signage complying with ICC A117.1 shall be located at each door to an area of refuge....
-
1003.2.13.5.5 Identification
Additionally, tactile signage complying with ICC A117.1 shall be located at each door to an area of refuge....
-
Mounting Height and Location
Section 703.4 covers the mounting height and location of signs with tactile characters....
-
Designations: ADA Standard Section 216.2
Section 216.2 covers scoping requirements in the current ADA Standards for sign designations.
-
9. I already purchased a portable lift before March 15, 2012. Can I still use it?
If you have purchased a non-fixed lift before March 15th that otherwise complies with the requirements in the 2010 Standards for pool lifts (such as seat size, etc.), you may use it, as...
-
§382.57(c)(6) Input
(6) Input. Input devices must comply with paragraphs (c)(6)(i) through (iv) of this section.
-
§ 382.57(c)(6) Input
(6) Input. Input devices must comply with paragraphs (c)(6)(i) through (iv) of this section.
-
Stroke Thickness: ADA Standard Section 703.5.7
Stroke thickness of the uppercase letter “I” shall be 10 percent minimum and 30 percent maximum of the height of the character.
-
11B-703.5.7 Stroke thickness
Stroke thickness of the uppercase letter “I” shall be 10 percent minimum and 20 percent maximum of the height of the character. [2010 ADA Standards] 703.5.7 Stroke Thickness....
-
Pool Lifts
Pool Lifts Pool lifts must be located where the water level is not deeper than 48 inches. This provides the opportunity for someone to provide assistance from a standing position...
-
Seat Height
Seat Height The lift must be designed so that the seat will make a stop between a minimum of 16 inches and maximum of 19 inches (measured from the deck to the top of the seat...
-
Submerged Depth
Submerged Depth Lifts must be designed so that the seat will submerge to a minimum of 18 inches below the stationary water level. This will ensure buoyancy for the person on the...
-
Lifting Capacity
Lifting Capacity Lifts must have the capability of supporting a minimum weight of 300 pounds and be capable of sustaining a static load that is at least 1.5 times the rated load....
-
T505 Fare Collection Devices
[See subsections ...]
-
T602 Wheelchair Spaces
[See subsections ...]
