The length of the gripping surface on vertical standing supports shall be 18 inches (455 mm) minimum....
Search Results "Construction Support Facility"
-
M305.3.1.3 Vertical Position
-
11B-202 Existing buildings and facilities
[See subsections ...]
-
11B-202 Existing buildings and facilities
[See subsections ...]
-
11B-233 Public housing facilities
[See subsections ...]
-
11B-233 Public housing facilities
[See subsections ...]
-
11B-307.4.1 Guy braces
Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
-
11B-307.4.1 Guy braces
Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
-
5.4.2.2 Transfer and Positioning Support Length Recommendations for Imaging Equipment with Transfer Surfaces
For imaging equipment with transfer surfaces, the Committee recommends a transfer support be 28 inches minimum length and that a positioning support be 12 to 16 inches in length....
-
III−7.3100 Application (ADAAG §4.1.1(1))
ADAAG applies to all areas in new construction and alterations, except where limited by scoping requirements....
-
Triggering event. (Section-by-Section Analysis)
In § 35.151(c)(2) of the NPRM, the Department proposed that the commencement of construction serve as the triggering event for applying the proposed standards to new construction and alterations...
-
Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations Weight Scales
Specifically, section M303, patient positions equipment designed to support seated in a wheelchair....
-
F244.2.3.1 Outdoor Constructed Features
Where provided, at least one of each type of outdoor constructed features shall comply with 1011....
-
3 - Best practices for pre - construction meetings
3 - Best practices for pre - construction meetings Pre - construction meetings provide another commonly used technique to communicate the required needs of the project....
-
II-6.0000 NEW CONSTRUCTION AND ALTERATIONS
[See subsections ...]
-
§ 36.406 Standards for new construction and alterations.
[See subsections ...]
-
4.0 CONSTRUCTED FEATURES IN RECREATION SITES
[See subsections ...]
-
II-6.0000 NEW CONSTRUCTION AND ALTERATIONS
Regulatory references: 28 CFR 35.151.
-
Wetland Trail Design and Construction
Most experienced trail crews try to avoid wetlands because of the construction and maintenance problems they pose....
-
Outdoor Constructed Features in Common Use and Public Use Areas [F244.3]
Where outdoor constructed features are provided in common use and public use areas that serve camping units with mobility features, at least 20 percent, but no less than one, of each type...
-
M305.3.2.2 Vertical Position
The height of the lowest end of the gripping surface on vertical standing supports shall be 34 inches (865 mm) minimum and 37 inches (940 mm) maximum above the standing surface....
-
Construction Specification Institute
Construction Specification Institute While developing suggested tolerances for surface materials, the Construction Specifications Institute developed a suggested method for measuring ramp...
-
11B-307.4.1 Guy braces
Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
-
Trail Construction and Maintenance Notebook
The Missoula Technology and Development Center's "Trail Construction and Maintenance Notebook" contains basic trail building information....
-
Self-Service Storage Facilities: ADA Standard Section 225.3
Section 225.3 covers scoping requirements in the current ADA Standards for self-service storage facilities.
