free telephone hotline system that provides general information about the rights of air travelers with disabilities, responds to requests for information, and assists air travelers with time-sensitive...
Search Results "Elevator Door Timing"
Filters
Commonly Searched Documents
-
DOT Disability Hotline or Hotline:
-
D5
If there is a raised threshold, is it no higher than 3/4 inch at the door and beveled on both sides?...
-
M5
If there is a raised threshold, is it no higher than 3/4 inch at the door and beveled on both sides?...
-
A4.13.8 Thresholds at Doorways
particularly inconvenient for wheelchair users who also have low stamina or restrictions in arm movement because complex maneuvering is required to get over the level change while operating the door...
-
Hardware [4.25.4]
Hardware [4.25.4] Hardware should be exposed (as required for sliding doors in 4.13) and must: be automatic or operable with one hand operate without tight grasping,...
-
A4.13.8 THRESHOLDS AT DOORWAYS
particularly inconvenient for wheelchair users who also have low stamina or restrictions in arm movement, because complex maneuvering is required to get over the level change while operating the door...
-
III-7.5190 Dressing and fitting rooms
Technical standards are provided for doors, benches, and mirrors, with less stringent standards for alterations....
-
Application Based on Building or Facility Use: ADA Standard Section 201.2
Section 201.2 covers the application of the most current requirements based on the building or facility use.
-
11B-216.4.2 Areas of refuge and exterior areas for assisted rescue
Signs required by Chapter 10, Section 1009.9 at doors to areas of refuge and exterior areas for assisted rescue shall comply with Sections 11B-703.1, 11B-703.2, 11B-703.3, and 11B-703.5...
-
1630.2(n)(3)(III)
(III) The amount of time spent on the job performing the function;...
-
§1630.2(n)(3)(iii)
(iii) The amount of time spent on the job performing the function;...
-
California Department of Managed Health Care - Physical Access to Health Care Fact Sheet
If You Use a Wheelchair or Have a Hard Time Walking...
-
§ 37.151(a)
(a) At the time of submission of the initial plan on January 26, 1992—...
-
Acceleration
Again, recumbent bicyclists had the lowest 85th percentile elapsed times and manual wheelchair users had the highest 85th percentile elapsed times....
-
11B-802.3.1 Alignment
The floor surface of the companion seat shall be at the same elevation as the floor surface of the wheelchair space....
-
802.3.1 Alignment
The floor surface of the companion seat shall be at the same elevation as the floor surface of the wheelchair space....
-
802.3.1 Alignment
The floor surface of the companion seat shall be at the same elevation as the floor surface of the wheelchair space....
-
Direct Connections
Direct Connections At least one entrance that serves enclosed parking garages, pedestrian tunnels, or elevated walkways must be accessible where such connections are provided....
-
4.3.8 CHANGES IN LEVELS
If an accessible route has changes in level greater than 1/2 in (13 mm), then a curb ramp, ramp, elevator, or platform lift shall be provided that complies with 4.7, 4.8, 4.10, or 4.11,...
-
4.5.3 Slope
When the surface is not paved or is not elevated above the natural ground, slopes not steeper than 1:33 (3 percent) shall be permitted where necessary for drainage. ...
-
11B-802.3.1 Alignment
The floor surface of the companion seat shall be at the same elevation as the floor surface of the wheelchair space....
-
11B-802.3.1 Alignment
The floor surface of the companion seat shall be at the same elevation as the floor surface of the wheelchair space....
-
PHYSICAL PROVISIONS
Route ADAAG section 4.5 Ground and Floor Surfaces Usable with reduced ability to respond quickly to product requests Provide at least one mode that does not require a timed...
-
11B-703.2.7 Character spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....