Proposed 407.12 parallels existing 508 Standards § 1194.25(j), which applies side reach requirements to ICT that is “freestanding, non-portable, and intended to be used in one location.”...
Search Results "Seat Location"
Commonly Searched Documents
-
407.12 Reach Height (Section-by-Section Analysis)
-
11B-208.2 Minimum number
Accessible spaces can be provided in other facilities or locations, or, in the case of parking structures, on one level only when equal or greater access is provided in terms of proximity...
- Trimco LDH100 Series Lockdown Hardware
- Verifone MX 850 Point of Sale Machine with Credit Card Reader
- EZ-ACCESS Transitions® Modular Entry Mat
- American Bath Enterprises, Inc. AccessaBath Shower System
- Just Manufacturing Classroom Concealed Ledgemount Teardrop Handles Restricted Swing Faucet
- Just Manufacturing Concealed Classroom Faucet with High Rise Spout
- Mansfield Elementary Two-Piece Toilet 5326-4320
- Landscape Forms Inc. Austin Trash Receptacle
- GameTime Rock N Raft Play Component
-
B. Regulatory Flexibility Act
., aircraft with up to 60 seats/18,000 pound payload capacity). See 14 CFR 399.73....
-
233.1 General
Facilities with more than 50 beds covered by this part that provide common use bathing facilities shall provide at least one roll-in shower with a seat that complies with the relevant provisions...
-
3.3.1 Research Data
Access Board staff asked Clive D’Souza and Edward Steinfeld to reanalyze the AWM Project data to examine the adequacy of proposed transfer surface dimensions (30” x 15”) as a static seating...
-
11B-240.1.1 Additions
When the second phase is completed, at least 10 elevated play components must be located on an accessible route, and at least 7 ground level play components, including 4 different types,...
-
Rear Grab Bar
Saving space by locating a lavatory closer to the water closet on the same plumbing wall could only be accomplished by recessing the lavatory so that it does not overlap the clear floor...
-
240.1.1 Additions
When the second phase is completed, at least 10 elevated play components must be located on an accessible route, and at least 7 ground level play components, including 4 different types,...
-
A. Accessibility of Terminal Facilities and Services
You should also know where they are located within or without the terminal....
-
Trail Construction Techniques
ETA Editor's Note The above referenced "Trail Construction and Maintenance Notebook" is now located here: https://www.fhwa.dot.gov/environment/recreational_trails/publications/fs_publications...
-
5. Access and Construction Database
Access and Construction Database Within the first two years of the program, the City will create a database that will include: (1) lists and maps of all locations where curb ramps and...
-
11B-240.1.1 Additions
When the second phase is completed, at least 10 elevated play components must be located on an accessible route, and at least 7 ground level play components, including 4 different types,...
-
11B-240.1.1 Additions
When the second phase is completed, at least 10 elevated play components must be located on an accessible route, and at least 7 ground level play components, including 4 different types,...
-
1136A.1 Receptacle heights
Electrical receptacle outlets on branch circuits of 30 amperes or less and communication system receptacles shall be located no more than 48 inches (1219 mm) measured from the top of the...
-
Typical Transfer Techniques: Staff Assistance and Patient Lifts
using a transfer board and gait belt with handles 1.Gait belt with handles assists with guiding along transfer board 2.Transfer or sliding board acts as a bridge between wheelchair seat...