Notes: 1. See Section 1134A for bathrooms that are required to be accessible. 2. Twenty-four inches (610 mm) is preferred for strike edge clearance....
Search Results "Enhanced 9-1-1"
Filters
Commonly Searched Documents
-
1132A.5.2 Strike edge maneuvering space at doors
-
PRIVATE BUILDING OR FACILITY
[DSA-AC] A place of public accommodation or a commercial building or facility subject to Chapter 1, Section 1.9.1.2. [2010 ADAS] Private Building or Facility. ...
-
11B-306.2.3 Minimum required depth
Exceptions: 1. The toe clearance shall extend 19 inches (483 mm) minimum under sinks required to be accessible by Section 11B-212.3. 2. ...
-
Sales Counters
Exception 1 indicates that sales and service counters, which are addressed in section 227 (Sales and Service), are not required to comply with the requirements for dining and work surfaces...
-
12206(a)(2) Publication of plan
--The Attorney General shall publish the plan referred to in paragraph (1) for public comment in accordance with subchapter II of chapter 5 of title 5, United States Code (commonly known...
-
11B-407.2.2.2 Visible signals
Exceptions: 1. Reserved. 2. Reserved. [2010 ADAS] 2. ...
-
M302.4.2 Clearance Around Base
The width of the base permitted within this clearance shall be 26 inches (660 mm) wide maximum at the edge of the examination surface and shall be permitted to increase at a rate of 1 inch...
-
M305.2.2.2 Side Transfer Supports
EXCEPTIONS: 1. Where transfer surfaces are part of an articulating surface, the support shall be permitted to be 15 inches (380 mm) long minimum. 2....
-
M301.4.2 Clearance Around Base
The width of the base permitted within this clearance shall be 26 inches (660 mm) wide maximum at the edge of the examination surface and shall be permitted to increase at a rate of 1 inch...
-
1009.4.1 Clear Deck Space
A clear deck space of 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer wall....
-
LULA Elevator Dimensions
These dimensions permit a car at least 51 inches by 51 inches provided that the door has a clear width of at least 36 inches (408.4.1, Exception 1)....
-
1016.6 Openings
Openings in the surface of outdoor recreation access routes shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1016.6 Openings. ...
-
1.2.1
The statement must attest that the work does not cause any alteration or reconstruction of structural elements nor trigger structural rehabilitation per Title 24, Part 1, Section 4-309(c...
-
229.1 General
EXCEPTION: 1. Glazed openings in residential dwelling units required to comply with 809 shall not be required to comply with 229. 2....
-
M301.3.1 Transfer Supports (Section-by-Section Analysis)
The only change in the final rule was to update the cross reference to applicable transfer surfaces to accommodate the changes made to transfer surfaces, described above in Section IV.B.1....
-
407.4.6.1 Location
EXCEPTIONS: 1....
-
Technical Memorandum TM 2012-06 Wading Pools
The Department will defer to the following definition contained in the Texas Administrative Code, Title 25, Part 1, §265.182(157) based on 201.1: 265.182 (157) Wading Pool – A Class D...
-
407.4.6.1 Location
EXCEPTIONS: 1....
-
Gripping Surface Cross Section and Clearances M301, M302, and M305.2
The transfer supports shall be located at a maximum distance from transfer surface of 1 ½ inches....