When the slope of a sidewalk that is an accessible route becomes steeper than 1 to 20, railings and edge protection are required for safe use....
Search Results "Surface Slope"
Filters
Commonly Searched Documents
-
Introduction
-
11B-604.3.2 Overlap
2-11B, dated 9/9/14, which includes the following interpretation of Subsection 11B-604.3.2: Showers are fixtures including a 30 inch x 60 inch clear receptor with a minimum/maximum slope...
-
11B-604.3.2 Overlap
2-11B, dated 9/9/14, which includes the following interpretation of Subsection 11B-604.3.2: Showers are fixtures including a 30 inch x 60 inch clear receptor with a minimum/maximum slope...
-
1150A.1 General
Test No. 1 -- Individual Building Test may only be used if the site has terrain over 15 percent slope. Test No. 3 -- Unusual Characteristics Test may be used if applicable....
-
Bradley Chrome-Plated Robe Hook 9118
Bradley Chrome-Plated Robe Hook Model 9118 Surface-Mounted - Exposed Mounting Heavy-Duty Chrome-Plated Brass Satin Chrome Finish available using -81 Available...
-
Bradley Contemporary Series Chrome Plated Double Robe Hook 912
Bradley Contemporary Series Chrome Plated Double Robe Hook Model 912 Surface-Mounted - Concealed Mounting Chrome-Plated Brass Double Robe Hook For Single...
-
Bradley 1 Station Verge Lavatory System LVRD1
See the Verge in detail (video) Verge image gallery Available in Evero Natural Quartz Surface Evero Natural Quartz Materials are now GREENGUARD Certified as low-emitting materials...
-
Bradley Channel Frame Mirror with Shelf 7815
Bright polished stainless steel frame Roll-formed channel frame Theft resistant mounting Integral shelf, 5-1/2" deep Alternate reflective surfaces available...
-
Wikk Industries Inc. Bollard With Push Plate PART # BPFSMPREP36PCCL
Surface mount with concealed mounting base. 1 prep at 36”AFF for ADA curved switch. Welded Flat top(FT)....
-
Feature 1 - Parking and Passenger Drop-Off Areas
In order to be usable, the access aisle must be level, clear of gravel or mud, and the surface must be in good condition without wide cracks or broken pavement....
-
Vanity Counter Tops
The Board has removed the minimum surface requirement (2 square feet) for vanity counter tops....
-
Curb Ramps at Marked Crossings and Vehicular Lanes
width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...
-
Benches
If benches are located in wet areas, the surface must be slip-resistant and designed not to accumulate water....
-
224.6 Housing at a Place of Education
suites and clustered sleeping rooms) or on floors containing accessible sleeping rooms with mobility features shall provide turning spaces that comply with section 809.2.2 and kitchen work surfaces...
-
3. Buttock-Popliteal Length
The median buttock-popliteal length provides an upper bound for the depth of a seating surface....
-
3.3 Data Sources
Early on, it became clear that some Committee members were unfamiliar with issues raised during transfers from a wheelchair or scooter onto a surface such as an examination table....
-
4.3.3 Imaging Equipment Used for Interventional and Biopsy Procedures with Sedated Patients
patients undergoing these procedures receive some form of sedation prior to transfer.CC When sedated, all patients – regardless of their physical abilities – are assisted onto the transfer surface...
-
Beach Access Routes
A beach access route is a continuous, unobstructed path that crosses the surface of the beach and provides pedestrians access to the water....
-
Front grab bar protocol
The preferred grab bar height was measured between the floor and the top of the grab bar surface. ...
-
Edge Protection [4.8.7]
A rail mounted close enough to the ramp surface to prevent passage of a 4 inch diameter sphere can function like a curb in keeping front casters from getting stuck on vertical posts and...
-
Sales and Service Counters
This provides a lowered surface where goods and services and money can be exchanged. An alternative solution is to provide an auxiliary counter nearby....
-
TTYs
This included a requirement that the touch surface of TTY keypads be 30 to 34 inches high (704.4.1). Comment....
-
11B-703.4.2 Location
When tactile signs are mounted inconsistently on surrounding wall surfaces, or mounted on the door itself, they are difficult to find and may create a safety hazard....
-
M305.2.4 Cross Section (Section-by-Section Analysis)
The Access Board sought input in MDE NPRM preamble question 21, on whether the gripping surfaces of current transfer supports on different types of equipment meet the cross sectional dimensions...
