Waviness index may be a more appropriate measure to include if floor profilers are used....
Search Results "Court Floor Holding Cell"
Filters
Commonly Searched Documents
-
1.1.8 Alternate measurement tools
-
Area of Refuge Identification [IBC §1007.6.5 (2003), §1003.2.13.5.5 (2000)]
In addition, areas of refuge are not required in open parking garages, apartment buildings, detention and correctional facilities, or open exit stairways between floors in buildings with...
-
11B-604.7 Dispensers and disposal units
The outlet of the dispenser shall be 15 inches (380 mm) minimum and 48 inches (1220 mm) maximum above the finish floor and shall not be located behind grab bars....
-
Allegion Falcon 1790 Series Exit Devices
Strikes: TD35 strike supplied standard Latchbolt: 1" thickness, 3/4" throw Dogging Feature: Hex Key Dogging standard, except EL where must use hold back feature Cylinder...
-
Norton Surface Mounted 5700 Series Low Energy Door Operator
opened manually if desired Norton® 1601/1601BF series door closer Non-Handed Unit Activation Options: wall switches, motion sensor, radio frequency device End-User On/Off Switch Hold...
-
Acoustiguide Guide U+ Tour Guiding System
predefined network Audio Hub allows two audio sources to be transmitted to any FM receivers in the room Loudspeaker comes with an integrated receiver Carry Case holds...
-
Unity Surfacing Systems Tough-Land Surfacing
Demand for indoor and outdoor applications of our rubberized safety surfacing, flooring and paver products are becoming more popular then ever before....
-
Willoughby Industries WAF-3603 AquaFount® Three Station Half Round 36" Solid Surface Deep Bowl Washfountain
This excludes Floor Mounted Foot Operated (FO) models. Optional Features: AquaFount® washfountains offer liquid soap dispensers as optional accessories....
-
Caroma® USA Sydney Smart 305 Easy Height Elongated 1 Piece Toilet
Further reference must be made to the relevant sections of Easy Height Standards For Accessible Design with current amendments to determine clear floor space, grab bar, and operation requirements...
-
ADDENDUM TO PHASE I FINAL REPORT: Points of Clarification
One subject could not transfer higher or lower than their device's seat to floor height. ...
-
11B-106.5 Defined terms
TRANSITION BOARDING PIER BOAT LAUNCH RAMP BOAT SLIP BUILDING BUILDING OFFICIAL CATCH POOL CCR CHARACTERS CHILDREN’S USE CIRCULATION PATH CLEAR CLEAR FLOOR...
-
American Association on Health and Disability (AAHD)
AAHD holds leadership roles on national coalitions and task forces in both the private and public sector....
-
Height Requirements
revised to specifically cover operable parts that are "intended for use only by service or maintenance personnel," "electrical or communication receptacles serving a dedicated use," and "floor...
-
1132A.5.1 General
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....
-
106 Definitions
unnecessary, in most cases due to changes in certain scoping or technical requirements: "accessible route," "area of refuge," "automatic door," "destination-oriented elevator," "ground floor...
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
In this case, the spring rocker being replaced would need to have the rocker seat height between 11 and 24 inches and clear floor or ground space and maneuvering space provided adjacent...
-
1007.1 Accessible means of egress required
In assembly spaces with sloped floors, one accessible means of egress is required from a space where the common path of travel of the accessible route for access to the wheelchair spaces...
-
16. If a play surface is replaced with an accessible surface and the existing ground level play components are not accessible, do the components need to be replaced?
If the alteration to the play area only involves the surfacing, only the surface along accessible routes, clear floor or ground spaces, and maneuvering spaces must comply with the ASTM F...
-
4.3.11.2 Size
EXCEPTION: The appropriate local authority may reduce the minimum number of 30-inch by 48-inch (760 mm by 1220 mm) areas to one for each area of rescue assistance on floors where the occupant...
-
General [9.1.1]
Objects with leading edges above 27 inches and below 80 inches above the floor cannot project more than 4 inches unless there is a tactile cane detectable cue below the object....
-
4.17.3 SIZE AND ARRANGEMENT
If the depth of toilet stalls is increased at least 3 in (75 mm), then a floor-mounted water closet may be used....
-
Historic Preservation [4.1.7]
These requirements address accessible routes, ramps, entrances, toilet rooms, access between floors, and displays....
-
A4.5.3 CARPET
When both carpet and padding are used, it is desirable to have minimum movement (preferably none) between the floor and the pad and the pad and the carpet, which would allow the carpet to...
-
Tactile wayfinding
A visitor followed a ridge along the floor and when there were objects that were freestanding in the middle of the room, the texture changed to three intersecting ridges to indicate you...
