Search Results "Curb Ramp Bottom Landing"
Commonly Searched Documents
- DSA Drawing 11B-406.6-5 Raised Island next to Curbs and Gutters (2016 CBC)
- 
    
  
  4.7.2 SLOPE
  Slopes of curb ramps shall comply with 4.8.2. The slope shall be measured as shown in Fig. 11.... 
- 
    
  
  4.7.2 Slope
  Slopes of curb ramps shall comply with 4.8.2. The slope shall be measured as shown in Fig. 11.... 
- 
    
  
  4.7.5 SIDES OF CURB RAMPS
  If a curb ramp is located where pedestrians must walk across the ramp, or where it is not protected by handrails or guardrails, then it shall have flared sides; the maximum slope of the... 
- 
    
  
  4.7.5 Sides of Curb Ramps
  If a curb ramp is located where pedestrians must walk across the ramp, or where it is not protected by handrails or guardrails, it shall have flared sides; the maximum slope of the flare... 
- 
    
  
  B7
  If there is a curb between the access aisle and the accessible route to the building, is there a curb ramp that meets the following requirements: [ADA Standards § 4.7] Yes No... 
- 
    
  
  Sides of Curb Ramps [4.7.5]
  Where pedestrians cross the ramp, curb ramps are required to have side flares; sharp returns present tripping hazards.... 
- Designing Sidewalks and Trails for Access, Part II of II: Best Practices Design Guide
- 
    
  
  4.8.2* Slope and Rise
  The least possible slope shall be used for any ramp. The maximum slope of a ramp in new construction shall be 1:12. The maximum rise for any run shall be 30 in (760 mm) (see Fig. 16).... 
- 
    
  
  4.8.2* SLOPE AND RISE
  The least possible slope shall be used for any ramp. The maximum slope of a ramp in new construction shall be 1:12. The maximum rise for any run shall be 30 in (760 mm) (see Fig. 16).... 
- 
    
  
  A8
  Does an accessible route connect the curb ramp to the shelter’s accessible entrance? [ADA Standards § 4.1.2(1)] Yes No... 
- 
    
  
  11B-406.5.2 Width
  The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 48 inches (1219 mm) minimum.... 
- 
    
  
  11B-406.5.2 Width
  The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 48 inches (1219 mm) minimum.... 
- 
    
  
  11B-406.5.2 Width
  The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 48 inches (1219 mm) minimum.... 
- Figure 405.9.1 Extended Floor or Ground Surface Edge Protection – Drawing from the U.S. Access Board
- 
    
  
  11B-402.2 Components
  Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared... 
- 
    
  
  402.2 Components
  Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared... 
- 
    
  
  402.2 Components
  Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared... 
- 
    
  
  11B-402.2 Components
  Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared... 
- Show us your #CrappyCurb
- 
    
  
  405.2 Slope
  Ramp runs shall have a running slope not steeper than 1:12.... 
- 
    
  
  405.2 Slope
  Ramp runs shall have a running slope not steeper than 1:12.... 
- 
    
  
  405.2 Slope
  Ramp runs shall have a running slope not steeper than 1:12.... 
- 
    
  
  11B-402.2 Components
  Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared... 
 
              