1. Thresholds with a change in height of not more than ¼ inch (6.35 mm) may be vertical.
Search Results "Bus Rapid Transit"
-
1132A.4.1, Item 1
-
Value Contrast (slide 9)
Fixed Surfaces To show where vertical and horizontal surfaces meet is very important. To show edges is very important. And one place where this is really important, even though...
-
10.3.1(15)
(15) Where clocks are provided for use by the general public, the clock face shall be uncluttered so that its elements are clearly visible. Hands, numerals, and/or digits shall...
-
Thresholds [§404.2.5]
Thresholds [§404.2.5] The height of thresholds is limited to 1/2” in new construction. The edge must be beveled 1:2 maximum above a height of 1/4”. A maximum height of 3/4” is...
-
§ 37.147 Considerations during FTA review
In reviewing each plan, at a minimum FTA will consider the following:
-
1132A.4.1, Item 1
1. Thresholds with a change in height of not more than ¼ inch (6.35 mm) may be vertical.
-
§ 37.149 Disapproved plans
[See subsections ...]
-
Section 37.143 Paratransit Plan Implementation
Section 37.143 Paratransit Plan Implementation As already discussed under §37.135, the states will receive FTA recipient plans for recipients of funding under 49 U.S.C. 5311...
-
§ 38.179(a)
(a) New and used trams consisting of a tractor unit, with or without passenger accommodations, and one or more passenger trailer units, including but not limited to vehicles...
-
§8.24(d) Transition plan and time period for structural changes
(d) Transition plan and time period for structural changes....
-
a) Curb Ramps
Consistent with its Curb Ramp and Sidewalk Transition Plan, the City installs approximately 1,200 new curb ramps each year....
-
Handrail Extensions
Handrail extensions are not required where gangways and transition plates connect and both are provided with handrails....
-
T208.2 Connection to Doorways
A passenger access route shall connect each wheelchair space to doorways that provide a means of accessible boarding and alighting in accordance with T208.2.
-
T404.2 Vehicle Floor and Boarding Platform Coordination
The design of non-rail vehicles shall be coordinated with the boarding platforms to minimize the gap between the vehicle floor and the boarding platforms.
-
§ 38.23(c)(3) Ramp threshold
The transition from roadway or sidewalk and the transition from vehicle floor to the ramp may be vertical without edge treatment up to 1/4 inch....
-
T215 Communication Features
First, a large transit agency, while noting that its fixed route bus fleet was already equipped with automated announcement systems, nonetheless expressed concern about the cost of complying...
-
11B-406.5.7 Cross slope
The cross slope of curb ramps and blended transitions shall be 1:48 maximum....
-
11B-406.5.7 Cross slope
The cross slope of curb ramps and blended transitions shall be 1:48 maximum....
-
11B-406.5.7 Cross slope
The cross slope of curb ramps and blended transitions shall be 1:48 maximum....
-
11B-406.5.4 Floor or ground surfaces
Floor or ground surfaces of curb ramps and blended transitions shall comply with Section 11B-405.4....
-
11B-406.5.4 Floor or ground surfaces
Floor or ground surfaces of curb ramps and blended transitions shall comply with Section 11B-405.4....
-
11B-406.5.4 Floor or ground surfaces
Floor or ground surfaces of curb ramps and blended transitions shall comply with Section 11B-405.4....
-
Department of Transportation, Federal Transit Administration
Department of Transportation, Federal Transit Administration offers information on the public transit provisions of the ADA....
-
R208.1 Where Required
Detectable warning surfaces complying with R305 shall be provided at the following locations on pedestrian access routes and at transit stops: 1....